ARCTIS 1333-6 i Integrating Freezer Operating and Installation Instructions
Dear customer, Before placing your new refrigerator/freezer into operation please read these operating instructions carefully. They contain important information for safe use, for installation and for care of the appliance. Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance.
Contents Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Disposal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Appliance Packaging Information . . . . . . . . . . . . . . . . . . . . . . . 5 Disposal of old Appliances . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Remove transport safeguard . . . . . . . . . . . . . . . . . . . . . . . . . 6 Starting up and temperature regulation . . . . . . . . . . . . . . . .
Safety Please read this instruction book before using the appliance and retain for future reference. These warnings are provided in the interests of your safety, ensure you understand them fully before using the appliance. Intended use ¥ The appliance is intended for use in the home. It is suitable for the freezing and storing of frozen food, as well as for making ice.
extinguisher refill cartridges etc in the refrigerator/freezer. ¥ Bottles and cans must not be placed in the freezer compartment. They can burst when the contents freeze, high carbonate content drinks can even explode! Never store lemonade, juices, beer, wine, sparkling wine etc. in the freezer compartment. ¥ Ice cream or ice cubes can cause Òfrost/freezerÓ burns if consumed straight from the freezer. ¥ Do not touch frozen food with wet hands. Your hands could freeze to the food.
Warning! Before disposing of old appliances make them inoperable. Remove plug from mains, sever the power cable, remove or destroy any snap or latch closures, to prevent small children being trapped inside. ¥ Information concerning collection schedules or locations can be obtained from the local disposal authorities or town hall. Remove transport safeguard The appliance and the interior fittings are protected for transport. ¥ Remove all adhesive tape and packing pieces from the interior of the appliance.
Operating and indicator panel A B C D A Fast feezing knob B Fast feezing light (yellow) C Alarm light (red) D Operating light (green) E ON/OFF knob F Temperature regulator knob E F The green pilot lamp (D), which comes on when the mains voltage is available and the ON/OFF knob is pushed. Switch the temperature regulatore to a number position, the refrigerating unit automatically operates by system control.
Ð excessive amounts of fresh food are placed inside; or Ð if the appliance door is open for too long. Important note: if you operate the fast-freeze switch or adjust the temperature regulator, it may happen that your applianceÕs refrigeration motor does not start immediately but only after some time. This does not mean that your appliance has a fault.
Ice pack There is an ice pack in one drawer of the freezer. In the event of a power failure or malfunction, the ice pack will lengthen the amount of time it takes for the frozen food to become too warm by several hours. The ice pack can only fulfil this task optimally if it is placed in the uppermost drawer, at the front, above the frozen food. You can use the ice pack for cooling cold bags. Freezing and storing frozen food You can use your freezer for freezing fresh food yourself.
Important! Do not touch frozen food with wet hands. Your hands could freeze to the food. 1. Place the packed food in the drawers. Place food to be frozen As shown in figure. Unfrozen food must not touch items already frozen, otherwise the frozen food could begin to defrost. 2. Press the fast freeze button 24 hours before introducing fresh food for freezing of fresh food. The yellow light comes on. 3. Place frozen foods in the drawers sorted by type, as far as possible.
¥ By attaching the included index-tabs to the drawers, they can be marked according to which type of foods the individual compartments contain. Defrosting The freezer compartment, however, will become progressively covered with frost. This should be removed with the special plastic scraper provided, whenever the thickness of the frost exceeds 4 mm. During this operation it is not necessary to switch off the power supply or to remove the foodstuffs.
Switching off the appliance 1. 2. 3. 4. To switch off the appliance, turn the temperature regulator to position "0" or disconnect from the electricity supply. If the appliance is not going to be used for an extended period: Remove all packages as well as ice trays. Remove the mains plug or switch off or turn out the circuit breaker or fuse. Defrost freezer compartment and clean thoroughly (see section: ÒCleaning and CareÓ). Leave the door open to avoid the build up of odours.
and with a little bicarbonate of soda added (5ml to 0,5 litre of water). Commercially available dish washing detergents may also be used. 4. Dry the appliance thoroughly. 5. When everything is dry place appliance back into service. Energy Saving Tips ¥ Do not install the appliance near cookers, radiators or other sources of warmth. High ambient temperatures cause longer, more frequent operation of the compressor.
Malfunction Possible Cause Remedy Appliance is not switched on Switch on the appliance. Mains plug is not plugged in Insert mains plug. or is loose. Appliance does not work. Fuse has blown or is defec- Check fuse, replace if tive. necessary. Socket is defective. Appliance cools too much. Mains malfunctions are to be corrected by an electrician. Temperature is set too cold. Turn the temperature regulator to a warmer setting temporarily..
If, after carrying out the necessary checks there is still a fault with your appliance please contact your local AEG Service Force Centre. In guarantee customers should ensure that the suggested checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown. Please note that proof of purchase is required for any in-guarantee service calls.
Guarantee Conditions Guarantee Conditions AEG offer the following guarantee to the first purchaser of this appliance. 1. The guarantee is valid for 12 months commencing when the appliance is handed over to the first retail purchaser, which must be verified by purchase invoice or similar documentation. The guarantee does not cover commercial use. 2. The guarantee covers all parts or components which fail due to faulty workmanship or faulty materials.
Installation Electrical Connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. WARNING Ð THIS APPLIANCE MUST BE EARTHED The manufacturer declines any liability should these safety measures not be observed. Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. The rating plate is inside, on the left. The appliance is supplied with a 13 amp plug fitted.
Installation Location The appliance should be set up in a well ventilated, dry room. Energy use is affected by the ambient temperature. The appliance should therefore Ð not be exposed to direct sunlight; Ð not be installed next to radiators, cookers or other continuossources of heat; Ð only be installed at a location whose ambient temperature corresponds to the climate classification, for which the appliance is designed.
Housing dimensions Height Depth Width 880 mm 550 mm 560 mm Instructions for building-in Apply joint the sealing strip as shown in figure. D765 A Push appliance into the housing until stop strip (A) touches the kitchen unit. D022 If after having carried out the previously described operation there is still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A).
Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grille (C) and hinge cover (D) into position. D C D727 Apply covers (B) on joint cover lugs and into hinge holes.
50mm Place guide (A) on the inside part of the furniture door, up and down as shown in the figure and mark the position of external holes. After having drilled holes, fix the guide with the screws supplied. A 20 m m PR166 Fix cover (C) on guide (A) until it clips into place. A C PR33 Open the appliance door and the furniture door at 90¡. Insert the small square (B) into guide (A). Put together the appliance door and the furniture door and mark the holes as indicated in the figure.
Should the lining up of the furniture door be necessary, use the clearance of slots. At the end of operations, it is necessary to check if the door of the furniture closes properly. PR168 Fix cover (D) on guide (B) until it clips into place. B D PR167/1 Regulations, Standards, Guidelines This appliance was designed for household use and was manufactured in accordance with the appropriate standards.
AEG HausgerŠte GmbH Postfach 1036 D-90327 NŸrnberg http://www.aeg.hausgeraete.