CONTENTS Page Electrical connection 3 — Installation in the kitchen worktop — Use of heating cooking areas — Safety — Cleaning and care — Service IMPORTANT Before thé hob is installed record the model and KD numbers here. If you require service to the hob you will be asked for this information. These numbers are found on the rating plate on the under~ side of the hob. Note: This appliance is manufactured in compliance with the radio interference requirements of EEC directive No. 82/489/EEC.
30V 3N 22GY -3y P Ties . 1z34s . FEE oL cave Sexism 7 gy cove sx2hmn kST " L 1 12345 220 200% s Y2345 RQV-ENA el ) 2 cable In25mmt § omp omp L Beetle batsman Ensure only molter sheath of mains cable is secured in cable clamp ‘C". . Connect the wires 1o the terminal block according to the wiring diagram on the plate for the applicable electric network { single phase-three phase-three phase with neutral-two phase with neutral }.
Proper installation. Be sure your appliance is properly jingled and earthed by a qualified technician. Never use your appliance for warming or heating the room. Do not leave children alone. Children should not be left alone or unattended in the area where the appliance is in use. They should never be flowed to sit or stand on any part of the appliance. Wear proper clothing. Loose-fighting garments should never be worn while using the appliance. User servicing.
AEG Austerity AG Postnatal 1036 D-90327 Nirenberg © Copyright by AEG H 260 288 040 1193/02 AEG Domestic Appliances Ltd Customer Care Department 5877 High Street Slough Berkshire 8L1 1DZ Telephone: 08705 350350