Summary paps DESCRIPTION 3 USE gas burners 4-5 MAINTENANCE 6 INSTALLATION building-in 7 connecting and adjusting the gas 8-9 electrical connection 10 GUARANTEE 11 GENERAL DESCRIPTION Overall dimensions Building-in-dimensions {em} (cm} Width ; §6.5 Width © 63.5 Depth @ 52 Depth : 48 Height : 3 GAS BURNER NATURAL CHARACTERISTICS BUTANE [PROPANE | GAS Heat capably Mammy 133.1 w12 ]| 9.
DESCRIPTION 1st burner tas! burner “reamer Ll 2.9 kW ISR gy L Lyl / semi-fast burner 1,45 kW GAS SAFETY REGULATIONS s a legal requirement that all gas appliances be installed by competent persons in accordance with tha above regulations. Failure 1o stall appliances correctly could deaf o prosecution i is your own tester, and that of safety, fo ensure that the law is complied wish, The hob souks be installed in accordance with the Gas Safely negotiations, C.P. 334 Part 1.
The gas burners USE Operation A guide mark above each control indicates which burner Is bling used. Each burner Is supplied with gas by a tap which incorporates a safety catch and a slow burning position. THESES w78 g High Low oft fame flame Intermediate positions are available between the high and low points on 1he control. Lighting the burners Turn on the gas tap. Turn the knob on o the tell uni position ¢y {correct ignition smelting} Depress the knob This produces the sparks and ignites the burner.
USE . The gas hab Is fitted with boomers of different sizes and outputs, it Is Important to know how to make use of the resulting difference in prows : ~ usa the highest output 16 bring to boll, 1o seal meat and generally for a¥ foods which must be cocked rapidly. Use the small burner for stews and sauces. Avoid billing loos rapidly. This reduces the flavors and destroys the texture. Never use the same saucepans on gas boomers and electric hotplates.
Burners caps Pan supports The enameled parts The control panel MAINTENANCE The burner caps are simply placed on the numbers. Care must be taken when refilling the caps to ensure that the recess lights into the projection below. Just Wit them ofi and clean with a damp, slightly soapy sponge. Do not immerse tha burner caps or pan supports in cold water immediately after use to avoid cracking the enamel from the thermal shock.
INSTALLATION The unlit which the hob Is to be bullion. as well as the casing of adjacent units must be harsh in a material resistant to a temperature of 100 © or coated In such a material and must be fixed with a glue that Is heat resistant In order to avoid il becoming unstuck. i there iIs a drawer below the hob. avoid storing heat sensitive terns such as plastics, spray cans, enc. Take note of the dimensions of the cut-out allow at stasis fem beneath the hob to ensure good circulation of air. 635 v_'\ \ A
Adjusting the burners Replacing the injectors INSTALLATION Hobs fitted Into kitchen units must be connected by means of a rigid gas supply pipe. The hobs are lifted with a 1/2 = BSP, male connector positioned at the rear right hand corner, connect gas supply pipe in iron or copper, starting from the male connector. Male provision for a connection that can be taken apart and Is easily accessible, NOTE : the 1/2° male connector can be moved through 180 © by slackening the union nut.
INSTALLATION When necessary {see table) the installation of ring is highly important as it ensures correct combustion and maximum burner efficiency. To access the lop's alr rings, remove the grid, the burner caps and head. e ai ting Remove the control knobs by puling upwards, Ult the knob Flanges away which are Just fitted together. Light the burner, then reduce to minimum output {marked small lame).
ELECTRICAL CONNECTIONS The gas hob is supplied with a cable which should be connected to a standard 13 Amp plug fitted with a 3 Amp fuse, in accordance with the wiring instructions below. CONNECTION The hob Is for connection o 240 vats 50 cycle ~ A C. singe phase supply. the wires in the mans lead are colored In accordance with the following code : green and yellow (Earth}, blue (Neutral), brown (Live).
GUARANTEE AEG {UK} Ltd guarantee (to the first recall purchaser} o replace ~free of charge for one year, a parts or components which fall due to workmanship or materials. AEG (UK} Lid will not replace or repair any delectable parts or rectify poor performance caused by misuse accidental damage, abuse, neglect, fully Installation or damage caused by non-adherence 10 the Instructions contained in this booklet. in order to establish the date of purchase.