Hello Allow me to introduce myself: 1 am your new AEG cooking appliance. From now on, | should like to make boiling and baking more pleasurable for you. Not simply because of my attractive appearance, but also thanks to my “intrinsic qualiies™ 1 am economical in terms of energy consumption; easy to operate, and simple to care. for. if you carefully read and follow my operating instructions before first use, you are sure to experience a good deal of joy when using me 1o boil, bake, roast, and gt your food.
S 8 g Contents Safety instructions. For the installer For the user Appliance description Features First use Operating the switches Hobs Features General Operating the hove, electronic displays Cleaning and care Caking area Special accessories What to coif.
For the installer For the user Safely instructions The safety requirements oblige manufacturers 1o give the following instructions: For installation in a kitchen unit, my attached installation instructions. must be noted. — When you use me 1o prepare your food, my oven doors and cooking plates become hot. Therefore keep small children well away from me. ~ Overheated fat and cooking oit may ignite. Prepare foods requiring fat or oil (chips} ony under constant supervision. Do not use me to heat your room.
AUSSIE 30 GEEK Appliance description Tl T o000 216 A Pilot lamp {red) for child/user sally device B Child/user safety switch C Front fell, push-in illuminated control knob for Automatic hob O Rear lef, push-in illuminated control knob for Autocratic ob E Rear right, push-in illuminated control knob for Automatic hob F Front right, push-in illuminated control knob for Automatic hob Features
Operating the control knobs Hob user protection $witching on the hob user protection Switching off the hob user protection 6 First use To operate my illuminated control knobs, the retracted control knob must be pressed so that i is released for operation. You must be a lite more careful with my control nabs for Automatic hobs. You can only um them clockwise (other right arras sting A. They are reset by turning to the left. #f-you switch on one of my control knobs it is Illuminated. To.
Bk KAZAKH-2 380 Hobs Depending on the specification of my hob, you wife find one of the Features following cooking plates: S My fast plate has a higher output to provide fast heating up times | Fast solid while making the most economical use of energy. tis seats usual. | plate H Single circuit plate The plate is controlled by the knob on the control panel.
Switch on the hob as normal. To engage the dual circuit press the touch contort on the hob surface. B0 Br ] Both heating circuits are controverted and switched off by the switch ont the contort panel. ® Elongated cooking piste Transcontinental knothole control panel sonsofbitches the circular plate and by additionally pressing the chaotic control on the hob surface the elongated plate can be activated to provide a large cooking surface.
KAFKA-2 8190 OB B Halogen piste Halogen o ] Special halogen lamps provide the plate with rapid healing properties. The plate is regulated by the relevant control knob or the control panel. M Warming zone My warming zone is intended for warming crockery and keeping food warm. iris switched an and off by the touch controls o the hob surface.
B User guidance Each of my cooking plates has five cooking symbols next to it The fights indicate the different speeds of cooking, eg from slow simmer to fast boil. The symbols have the following meanings: % Fast bailing or frying S8, Frying m Cooking and simmering of larger quantities Yef Low simmering L=l Warming B Residua heat indicator Each of my ceramic cooking plates has a residual heat indicator. it tomes nonwhite hobos hot and goes off when it has cooled down.
GATE 550 GE ILK General the correct pans W For best results use good quality pans with smooth flat bases. W The pan base should be thick and flat. Pans with uneven, distorted or rough bases cast iron) should not be used as they extend the cooking times and may cause damage to the cooking plates. B Cooking plates and pan base should be of the same or similar diameter. The pan should be placed centrally on the cooking plate. M Shiny based pans are unsuitable for use on halogen cooking plates.
important information when using the cooking plates Boiling/ frying on the automatic hob 12 {Ceramic and solid plates} After you have switched on one of my ceramic plates you will hears faint hum caused by my radiant heating elements. Po aot place aluminum foil or plastic containers on my hot ceramic hob, Do not aglow sugar or foodstuffs containing sugar to come in contact with my hot ceramic hob it will damage my hob.
KEN-2 590 BAKU The automatic system can be canceled by muting to 8. You can also use my aromatic hobs without the automatic system, You should then switch me on only as far as sifting 9. The following table saws you examples of the suitability of switch settings 110 9.
Ceramic hob general Cleaning and care Although ceramic hobs are easy fo clean they require regular care and cleaning to maintain therm in good condition, Let the hob cool down before cleaning. 1. Never use abrasive cleaners or scouring powders o scouring pads. 2. Clean the hob after every use wheels the silage is still mineral, Use a soft damp cloth and a lithe washing up liquid. Rub the hob dry using a soft clean cloth. Make sure that no residua! cleaning material is left on the hob. 3.
RPS-2 3/60 BAKU Heavy collage on the cooking plates can be cleaned with “Jif ora fine scouring powder and a damp cloth or sponge. After removing any residual leaning material switch platesonforashorttimetodry. Enameled and stainless steel surfaces must not be cleaned with any scouring powders or abrasive cleaning materials. Clean stainless steel surfaces with “Stael-fix" available from AEG Spare Parts or with stainless steel cleaners.
Special accessories | j[2a0] Extension cable KB 90 {length 4.20 m) E No. 611838705 {for the gabs. with user guidance) BEa Extension cable KB 9 {length 4.20 m) E No.
WIT 300 GRS WIDTH 3100 GEEK What to do if... (something goes wrong?} .. the Illumination of the control knoll does not work? ..the control lamp for the child/user safety device does not work? 1. May be you have not operated the switch quite correctly. Repeat your defection. 2. May be the fuses in the fuse-box are not in working order. ..
Service Should you be unable to locate the cause of the problem in spite of the above check-fist, please contact your AFG service department quoting the E and F numbers which you will find on the rear page of my instruction book. These numbers enable the service department o prepare as farad possible any spare parts required to rectify the fault on first call. This may save you money.