Contents Description of the appliance General details Extractor version Niter version Safety warnings for kitchen unit installer Electrical connections Safety warnings for electrician Safety warnings for user Hood operation Care and Maintenance Grease fighter Active carbon fighter Cleaning Replacing the lamps Technical details Special Accessories Technical Assistance Service Printed on recycled paper.
Description of the appliance 1} Pull-out panel 2} Grease filter support grid 3) Hob light 4} Fan speed cursor 5) Light switch General details The hood is supplied in the external evacuation version, but may also be used with the internal recycling function by inserting an active carbon filter (Special accessories). Exhaust vapors are pushed outwards by means of a pipe. i the exhaust pipe is in a horizontal position, it must be inclined upwards at a angle guarantee better evacuation.
Filter version Safety warnings for Kitchen unit installer l i Exhaust vapors are purified by means of an active carbon fighter (Special accessories) and directed back inside. To insert the active carbon filter, remove the grease filter grid. Fit the active carbon filer by inserting it first into the upper hooks and then into the lower ones; then lock into position by using the blocking tabs E (fig. 1}.
Hoods can only be used safely with appliances connected to a chimney if the room and/or flat (environmental combination} is ventilated from outside using a suitable ventilation hole approximately 500-600 cn? fare to avoid the possibility of a depression being created during operation ¢f the hood. If you have any doubts, contact the relevant controlling authority or building inspector’s office.
Safety warnings for user 16 Instating the socket directly above the hood or above the wall unit mounted above the hood offers the following advantages: 1. The socket cannot be seen. 2. The unit can be disconnected whenever required by simply taking out the plug. Electrical connections 230 V using fixed power supply line with plug. 240 V using fixed power supply line (Great Britain). {The unit should only be connected up by an authorized electrician}.
Hood operation The control panel of the fan hood is on the front of the appliance {see pag. 13). The two cursor switches are for the various fan functions: one is for the fan speed and the other is for the hob light. Thebutonwiththe symbols used to adjust the fan sped or intensity. it is advisable to use low speeds when cooking food that produces an average amount of steam and odor: the more steam and odor there is. the higher the speed should be. The button with the * & hab light.
Grease filter 18 Care and Maintenance Always turn off the appliance before carrying out any repair or maintenance work. For safety reasons, unplug at the Walt socket. The postpone of the grease filter 1§ 10 aspirate grease campaniles which form during cooking and it should always be used, either in the textual evacuation or internal recycling function, The synthetic filter is thin (approx. 1 mm) and is found inside the arid. It should be replaced as soon as internal discoloring becomes.
This filter is used when the hood functions for internal recycling. The original AEG active carbon filter should be used (see Special accessories). it is neither washable nor re-usable. in normal cooking conditions, we recommend that it be replaced every 4 monies, Ta replace the active carbon filter, push the locking tabs Inwards. amid the filter downwards (see diagram paragon. 14y When ordering a new active carbon fitter, indicate the mode description and fan hood serial number.
20 Technical details Weight: 3300 43RD Net: 9.7 Kg 88Kg Maximum absorbed power: 220 W Motor absorption: 140W Lighting: 2 x40W (E14) Fan powers {speed), speed in compliance with DIN 44971 Tevet: 1 2 3 Extractor: 152 m¥h 208 m¥%h 202 m¥h Version: 120 m¥h 181 m¥h 233 m¥h Special accessories MKZ telescopic wall pipe e-Nr.