400 D Köksfläkt Ventilator Liesituuletin Emhætte Cooker Hood Instruktionsbok Bruksanvisning Käyttöohje Brugsvejledning Operating and Installation Instructions
S N FIN DK UK Innehållsförteckning .........................................................2 Innholdsfortegnelse ....................................................... 12 Sisällysluettelo ..............................................................22 Indholdsfortegnelse ....................................................... 32 Contents ............................................................................ 43 Contents Safety instructions ..........................................................
Use of cooker hood • This appliance is for domestic use only in a normal household. • Never leave any deep-frying, melting fat, paraffin or any other inflammable liquid unattended on the hob. In the event of fire: Immediately switch off the cooker hood and the cooker. Note! Cover the fire. Never use water. • Never do any flambé cooking underneath the cooker hood. It can cause a fire. Remember that overheated fat may spontaneously ignite. Never leave the frying pan unattended.
Introduction Extractor version • The hood is supplied as an extractor unit and can also be used with a filtering function by fitting one charcoal filter (special accessory). • You will need original AEG charcoal filter for this function (see Special Accessories). • The unit features two outlet holes, one of which A is located on the top of the unit while the other B is located on the rear.
Using the cooker hood The control panel A: B: C: D: E: F: G: H: • The hood is fitted with one motor having several speed. Best results are obtained by using a low speed for normal conditions and high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking then you will get an underpressure in the kitchen. It should be left on after cooking for about 15 minutes or until all odours have disappeared.
Maintenance and cleaning Disconnect the cooker hood from the power supply prior to cleaning the appliance, either by removing the plug from the mains or removing the fuse. Clean the filter regularly. The grease deposits in the filter and discharge tube are fire hazards where a hotplate (or another heat source) is left on by error. Cleaning the hood Clean the outside of the hood using a damp cloth and a mild detergent. Never use corrosive, abrasive or flammable cleaning products.
After approximately three years of use, the charcoal filter should be replaced with a new, as the odour reduction capacity will be reduced. • Mounting Remove the grease filters and fit one LONG LIFE charcoal filter S on the rear side of each grease filter, fix each with two metal wires Z . Fig. 5. • To dismount proceed in reverse order. S Z S Fig. 5 Changing the light bulb • • • • • 48 Disconnect the unit from the mains power supply. Remove the grease filters.
If the cooker hood will not operate Check the following prior to calling after sales service: • Has a fuse burnt? Check both fuses and replace if necessary. • Is the power supply plug inserted properly in the power outlet? • Has the flexible tube been mounted correctly? • Is the anti-grease filter clean? • Are the light bulbs intact and soundly fitted? If the problem persists, contact the sales center, the after sales service center or an authorized technician. Only use original spare parts.
European Guarantee If you should move to another country within Europe then your guarantee moves with you to your new home subject to the following qualifications: The guarantee starts from the date you first purchased your product. The guarantee is for the same period and to the same extent for labour and parts as exists in the new country of use for this brand or range of products. This guarantee relates to you and cannot be transferred to another user.
Special accessories Charcoal KF 14 E-Nr. 942 120 604 Installation Unpacking Check that the cooker hood is not damaged. Transportation damages should immediately be reported to the transport company. Damages, faults and missing parts should immediately be reported to the retailer. Dispose carefully of the packaging material so that it is out of the way of small children. Position The cooker hood should be mounted freely hanging on the wall.
Wall unit mounting - Fig. 6 • Make the holes on the bottom of the cupboard (2), using the drilling template (1). Provide an hole also for exhausting pipe (4) ONLY if is decided to use the hood in Exhausting version (3). • From inside the cupboard, insert the 4 supplied screws (5) and tighten them in the appropriate holes on the appliance. Fig.
Wall mounting - Fig. 7 • Sign a centerline onto the wall (1). Fit the template onto the wall (2). • Fix the drilling template to the wall. • Make 3 Ø 8mm holes in the wall (3), 2 at upper points, 1 as desired at lower points. • Insert the three Ø 8mm expansion plugs into the wall (4). • Insert 2 5x45 screws (5) but do not tighten them completely, hang the hood (6). • Adjust the unit so that it is positioned at a right angle to the wall by turning the two screws on lower side (7).
54
55
AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www.aeg.hausgeraete.de © Copyright by AEG LI1WCB Ed.