BEWS18-115 X BEWS18-125 X Original instructions
Important! It is essential that you read the instructions in this manual before operating this machine. Subject to technical modifications.
14 18 12 10 4 9
16 START STOP 6 17 8 5
1 Remove the battery pack before starting any work on the machine.
5-100 % 50-75 % 25-50 % 0-25 % 7
1 2 3 8
1 2 click 0° 30° 60° 30° 60° 9
1 2 2 3 10 1
1 2 For Separating! 2 1 3 11
1 2 3 12
1 2 3 13
Accessory 1 2 14
1 2 15
START STOP START/LOCK 1 2 STOP 1 2 16
30° 17
LLO 1 Line Lock Out Function START Line Lock Out Function 2 3 4 5 STOP 6 START 18
If the control lamp is lit: The restart cut-out is active. The machine will not start if the battery is fitted whilst the machine is switched on. Switch the machine off and then on again.
Overload Protection 1 2 20 STOP START
The control lamp flashes: To protect the tool, please let it continue rotating with no-load, or reduce the load until the lamp is off; Load-dependent motor protection: if the motor is overloaded, it will trip the overload protection and the tool will automatically stop rotating. To continue working, switch the machine off and then on again.
TECHNICAL DATA Cordless Angle Grinder BEWS18-115 X BEWS18-125 X Battery voltage.............................................................................. .............................18 V ............................... 18 V Rated speed ................................................................................. .........................9000 min-1 ...................... 9000 min-1 Grinding disk diameter.................................................................. ...........................
m) Do not run the power tool while carrying it at your side. Accidental contact with the spinning accessory could snag your clothing, pulling the accessory into your body. n) Regularly clean the power tool’s air vents. The motor’s fan will draw the dust inside the housing and excessive accumulation of powdered metal may cause electrical hazards. o) Do not operate the power tool near flammable materials. Sparks could ignite these materials. p) Do not use accessories that require liquid coolants.
For accessories intended to be fitted with threaded hole wheel, ensure that the thread in the wheel is long enough to accept the spindle length. For cutting or separating use a closed protection cap, available as an accessory. Do not dispose of used battery packs in the household refuse or by burning them. AEG Distributors offer to retrieve old batteries to protect our environment. Do not store the battery pack together with metal objects (short circuit risk).
To obtain the longest possible battery life remove the battery pack from the charger once it is fully charged. For battery pack storage longer than 30 days: Store the battery pack where the temperature is below 27°C and away from moisture Store the battery packs in a 30% - 50% charged condition Every six months of storage, charge the pack as normal. www.aegpowertools.com.
Instruction for selecting and using the correct outer flange nut. Your AEG Angle Grinder has been supplied with two different outer flange nuts A & B, please familiarise yourself with the specific use of each nut before attaching an abrasive wheel to the angle grinder. FIXTEC NUT A STANDARD OUTER FLANGE NUT B Recommended for use with flat cut-off wheels up to a maximum thickness of 6mm Recommended for use with depressed centre grinding wheels with a thickness greater than 6.