DL 6250 -ml Köksfläkt Ventilator Liesituuletin Emhætte Cooker Hood Instruktionsbok Bruksanvisning Käyttöohje Brugsvejledning Operating and Installation Instructions
S N FIN DK UK Innehållsförteckning ............................................................ 2 Innholdsfortegnelse ........................................................... 13 Sisällysluettelo .................................................................. 24 Indholdsfortegnelse ........................................................... 35 Contents ............................................................................ 47 Contents Safety instructions .........................................
Use of cooker hood • This appliance is for domestic use only in a normal household. • Never leave any deep-frying, melting fat, paraffin or any other inflammable liquid unattended on the hob. In the event of fire: Immediately switch off the cooker hood and the cooker. Note! Cover the fire. Never use water. • Never do any flambé cooking underneath the cooker hood. It can cause a fire. Remember that overheated fat may spontaneously ignite. Never leave the frying pan unattended.
Using the cooker hood The control panel Best results are obtained by using a low speed for normal conditions and high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking then you will get an underpressure in the kitchen. It should be left on after cooking for about 15 minutes or until all odours have disappeared.The switches are located on the right-hand side of the hood. • the light switch switches the hood lamp on and off.
Maintenance and cleaning Disconnect the cooker hood from the power supply prior to cleaning the appliance, either by removing the plug from the mains or removing the fuse. Clean the filter regularly. The grease deposits in the filter and discharge tube are fire hazards where a hotplate (or another heat source) is left on by error. Cleaning the hood Clean the outside of the hood using a damp cloth and a mild detergent. Never use corrosive, abrasive or flammable cleaning products.
• Changing and cleaning the carbon filter - KF 8 Unlike other carbon filters, the LONGLIFE carbon filter can be cleaned and reactivated. At normal use the filter should be cleaned every second month. The best way to clean the filter is in the dishwasher. Use normal detergent and choose the highest temperature (65º C). Wash the filter separately so that no food parts gets stuck on the filter and later causes bad odours.
Changing the light bulb • Disconnect the unit from the mains power supply. • Unlock the lighting cover by twisting the bolts to the left and fold down the bulb cover. • Replace the old light bulb with a new light bulb of the same kind. • Close the bulb cover and relock it by twisting the bolts to the right. • If the light does not come on, make sure the bulb has been inserted in correctly before contacting the technical assistance service. Fig.
If the cooker hood will not operate Check the following prior to calling after sales service: • Has a fuse burnt? Check both fuses and replace if necessary. • Is the power supply plug inserted properly in the power outlet? • Has the flexible tube been mounted correctly? • Is the anti-grease filter clean? • Are the light bulbs intact and soundly fitted? If the problem persists, contact the sales center, the after sales service center or an authorized technician. Only use original spare parts.
European Guarantee If you should move to another country within Europe then your guarantee moves with you to your new home subject to the following qualifications: - The guarantee starts from the date you first purchased your product. - The guarantee is for the same period and to the same extent for labour and parts as exist in the new country of use for this brand or range of products. - This guarantee relates to you an cannot be transferred to another user.
Technical data Size Height Width Depth Light Grease filter Voltage Total power 14,2 cm 54,8 cm 28,5 cm 1x11 W 1 st. 230 V 295 W Extra accessories: Charcoal KLF 60/80 Charcoal KF 8 E-Nr. 610 899 421 942 120 399 Installation Unpacking Check that the cooker hood is not damaged. Transportation damages should immediately be reported to the transport company. Damages, faults and missing parts should immediately be reported to the retailer.
Mounting the cooker hood - Fig. 6 • Drill the base of the wall unit to allow for passage of the hood body. Fig. 9.1. • Drill the top of the wall unit to allow for passage of the exhaust pipe and the electrical cable. Fig. 9.1. • Remove the grease filter (1). • Remove the grease filter support frame, by pressing the two spring clamps located at the sides of the frame (2). • Through the top of the wall unit, insert a pipe with a diameter of 120mm or 125mm at the connection ring (3).
Fig. 9.1 3-F OK! OK! 5-C 4 5-C 6 6 7 7 7 7 2 Fig. 7 1 2 Fig.
Removing the hood from cabinet Follow these steps: • Remove the grease filter. • Remove the 4 additional screws from the frame. • Loosen the screws on the two fixing springs. Fig. 8. Fig. 7 • Push a flat screwdriver into the hole for the fixing springs (right and left) and push each of the fixing springs inwards. Fig. 9. • At the same time, pull the extractor hood (right and left) out of the cabinet. Re-install it as described above. Fig.
AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www.aeg.hausgeraete.de © Copyright by AEG LI1WBB Ed.