Product name: MACH4 Model name: X70 AEE UNMANNED AIRCRAFT SYSTEM Professional Leading Product Name: MACH4 Y12 Model Name: Y12 USER'S MANUAL Please read this manual carefully before use and keep it properly for reference.
CONTENTS ........................... ...................................................... ...........................1 1. Impo rt ant notes ............................................ 2. Product introduction ....................................... ............................................................... ................................ ........... 1 3. Safety precautions ......................................... .............................................. .......................................
6.3.4 Display of image transmission information ............... ....................................................................17 6.3.5 Map settings ............................................ ..................................................... .........................................17 6.3.6 Firmw are upgrade ......................................................................................................................... . .....18 6.3.7 Version information .................................
AEE Unmanned Aircraft System Professional Leading Important notes Please read the following notes carefully before using this product. Once using the product, it will be regarded as your approval and acceptance of all the contents in the manual This product is a high-tech electronic product integrating flight control and camera control. Under the condition of normal power supply and undamaged components,it can provide excellent flight control and camera surveillance.
AEE Unmanned Aircraft System Professional Leading * * * * * Ensure that the drone is the center of the circle when taking off and landing, and there are no moving people or obstacles within a radius of 10 meters. When operating this AEE unmanned aircraft system product, the drone should only be allowed to fly in a safe area away from the crowd, and it is important to pay attention to your own safety and people around.
AEE Unmanned Aircraft System Professional Leading Note: In the state of second-level low power, the aircraft will enter the protection mode, and will slowly descend to the ground vertically at the current position. At this time, the attitude and altitude of the aircraft can still be controlled by the remote control, but two points need to be noted: ① After the aircraft is in the state of second-level low power for 5S, it will start to land automatically, regardless of the middle of the throttle.
AEE Unmanned Aircraft System Professional Leading Battery level of Y12 remote control Status light display (blue light) Power ≥75% Four status lights are on 50% ≤ Power <75% Three status lights are on 25%≤ Power＜50% Two status lights are on Power＜25% One status light is on Power check after power on: After turning on the power of Y12 remote control, it will automatically enter the ground station software (hereinafter referred to as GS), and the battery level of the remote control will be displaye
AEE Unmanned Aircraft System Professional Leading Steps Illustration Description Step 1 Connect the power cord of "380W power"; Step 2 Insert the power adapter cable into the "DC-24v" interface of the 380w power, and the other end into the "DCINPUT" interface corresponding to the charger; Step 3 Insert the battery charging cable into the "OUTPUT" interface of the charger, the 6pin flexible flat cable into the "123456" interface of the charger, and the battery charging cable and 6pin flexible flat c
AEE Unmanned Aircraft System Professional Leading Parameter setting of the power battery charger of the aircraft [Parameter setting and charging] Set the charger parameters as follows after the battery and charger are connected: 1. Click the "PAUSE" button and change the battery type to "LIPO" under "BATTERY TYPE". (When the battery type keeps flashing, "UP" and "DOWN" buttons can be used to select the battery type); 2.
AEE Unmanned Aircraft System Professional Leading Illustration of the drone parts 【1】 Motor 【2】Gimbal 【3】Positive propeller 【4】Foldable arm L 【5】Foldable arm R 【6】Power switch 【7】Landing gear 【8】Airborne camera 【9】Counter propeller 【10】Foldable arm R 【11】Foldable arm L 【12】Battery pluggable switch 【13】GPS 【14】Antenna 【15】Battery
AEE Unmanned Aircraft System Professional Leading Folding & unfolding of the drone arm Press and hold the arm button to unfold the foldable arm, then release the button when the foldable arm matches the fixed arm. Push the foldable arm left and right to make sure that the arm is locked. Conversely, press and hold the arm button to fold up the foldable arm. (It is recommended to manually unfold the blades and fix them before power on.
AEE Unmanned Aircraft System Professional Leading Installation of airborne camera 1. ２． Align the two pins (shown in red) of the gimbal with the clamping holder (shown in red) of the gimbal and insert them into it, as shown below: Align the PCB contact of the gimbal with the signal pin of the quick release clamp, push the hanging plate upwards, and the gimbal will be locked when a “click” sound is heard. As shown below: 3.
AEE Unmanned Aircraft System Professional Leading Installation of the drone power battery 1. Let the battery interface face toward the battery holder: 2. Insert one end of the battery into the battery holder, and press the other end upward. When a "click" sound is heard, gently pull the battery outward to confirm if the battery is loose: 3.
AEE Unmanned Aircraft System Professional Leading Remote control The remote control is specially developed to cooperate with the AEE unmanned aircraft system, so as to facilitate the control of drone flight. The remote control can independently control the flight of the drone and simultaneously display the flight status and the real-time image of the airborne camera.
AEE Unmanned Aircraft System Professional Leading No. Category Type Qty. Brief description High speed：head free mode Medium Altitude hold/ positioning flight switching switch Threespeed toggle type 1 Left joystick Universal joystick 1 Control the throttle and the heading One button take-off/landing Push-button 1 One button take-off/landing One button route Push-button 1 After setting the route, one button controls the drone to fly according to the route.
AEE Unmanned Aircraft System Professional Leading Preparation of the remote control Antenna installation
AEE Unmanned Aircraft System Professional Leading Installation and removal of lens hood Align the position indicated by the red arrow and press the lens hood on the remote control.
AEE Unmanned Aircraft System Professional Leading Parameter setting of the remote control Altitude hold mode Huizhou Camera parameters: Under the parameter setting options, relevant parameters of the camera, such as camera resolution, loop coverage, time display, etc can be set.
AEE Unmanned Aircraft System Professional Leading Drone settings Under the functional parameter options, relevant parameters of the drone, such as: one button take-off altitude, first-level and second-level low-power alarm values can be set.
AEE Unmanned Aircraft System Professional Leading Display of image transmission information Under the functional parameter option, information of relevant image transmission, such as transmission bandwidth, transmission encryption, video resolution, module temperature and power can be viewed.
