Installation Instructions

ManualsBrandsAEE ManualsElectronicsMACH6

- 7 -

1.3.5 Attach & removal of gimbal and payload mount

1.3.5.1 Align the two pins (shown in red) of the gimbal with the clamping holder (shown in red) of the

gimbal and insert them into it (observe it carefully during installation, to avoid contact with the pin at

end of drone); push the gimbal to the clamping position until there’s “click” sound, make sure the gimbal

is clamped, and check if it is installed properly, as shown below:

1.3.5.2 Removal of gimbal

Removal the cradle head according to the arrow direction. As shown below:

While removal the cradle head, hold the cradle head with one hand and removal it with

another hand, to avoid falling and damage of cradle head.

AEE Unmanned Aircraft System

s o lProfes i na Leading

Summary of content (5 pages)

PAGE 1
AEE Unmanned Aircraft System Professional Leading 1.3.5 Attach & removal of gimbal and payload mount 1.3.5.1 Align the two pins (shown in red) of the gimbal with the clamping holder (shown in red) of the gimbal and insert them into it (observe it carefully during installation, to avoid contact with the pin at end of drone); push the gimbal to the clamping position until there’s “click” sound, make sure the gimbal is clamped, and check if it is installed properly, as shown below: 1.3.5.
PAGE 2
AEE Unmanned Aircraft System Professional Leading 1.3.5.3 Installation of payload mount Push in the payload mount according to the arrow direction in diagram until there’s “click” sound, make sure the payload mount is clamped and check if it is installed properly. As shown in figure below: 2 1 1.3.5.4 Removal of payload mount Removal the payload mount according to the diagram.
PAGE 3
AEE Unmanned Aircraft System Professional Leading Removal of double payload mounts. As shown in figure below: 1 2 3 4 Prompt: While removal the payload mount, hold the unlock button with one hand, hold the payload mount with another hand and move it out slowly according to the direction in diagram, to avoid falling and damage of payload mount during removal. 1.3.6 Installation & removal of smart battery 1.3.6.
PAGE 4
AEE Unmanned Aircraft System Professional Leading 3 Note: If the battery or its lock is not fastened normally, it may lead to poor contact of power supply, affect the flying safety, even flying failure and affect the flying experience. 1.3.6.
PAGE 5
AEE Unmanned Aircraft System Professional Leading 1.4 Installation of remote controller antenna As shown in figure below: 1.4.1 Removal of hood As shown in figure below: 1.4.2 Installation and removal of safety buckle and rope of remote control 1.4.2.