900MHz Speakers with 900 MHz Transmitter PLL SYSTEM NO NEED FOR TUNING Freedom From Wires listen Ary Wherever i your home
INTRODUCTION Congratulations on the purchase of your new WSP200 Wireless Stereo Speaker System. This System uses the latest 900 MHz High Frequency Radio Signal that can easily travel through walls, floors, ceilings or partitions to allow the finest stereo sound reproduction, You can use your Speakers almost anywhere in and around your home or, for outdoor activities, just place them in the location of your choice. There is no need to worry about cable connection between the transmitter and Speakers.
CONTROL LOCATIONS TRANSMITTER 1} LED Indicator (Power ON) 2) Power OFF Switch and Chance! Selector 3) AUDIO IN Jack (L) Connect to Music Source 4) AUDIO IN Jack (R) Connect to Music Source 5) DC Input Jack NS Cea SPEAKER 6) Frequency Channel Selector 7) Tone Control Knob 8) Power OFF and Volume Control Knob 9) DC Input Jack 10) Battery Compartment
INSTALLING THE TRANSMITTER You need to properly set up the Transmitter to send a wireless signal to the Speakers. There are two things you must do. First, provide power to the Transmitter, and second, connect the Transmitter to the Audio Source. 1) CONNECTING POWER {Al DC OPERATION Your Transmitter is supplied with a Battery Compartment. Insert four (4) x AA Alkaline batteries (not supplied) to the battery slot as indicated. Attach the battery compartment cover to the bottom of the Transmitter unit.
INSTALLING A SPEAKER CONNECTING POWER (A) DC OPERATION (with optional BP200SP Battery Pack sold on page 11) Open the battery cover located at the back of the Speaker unit. Insert the battery making sure the side with the contacts {located on the top edge) is inserted to make contact with the coil springs inside the compartment. Push the battery all the way in until you feel resistance from the coil springs inside the compartment.
OPERATION Follow these steps to obtain maximum listening performance 1) Make sure that your Transmitter and Speakers are set up according to the procedures given in this manual. 2} Turn on your Audio Source. 3) Switch the Transmitter to a Frequency Channel (Channel that has no interference. Refer to below for Precision Frequency Lock-In Tuning, 4) Rotate the CHANNEL Knob on the front of the Speakers to select the same channel (Channel selected on the Transmitter.
BATTERY OPERATION TRANSMITTER When the Transmitter is operated by fresh Alkaline batteries (four (4) AA cell snot included) the Transmitter will play for approximately 4-6 hours continuously. Once the battery power begins to decrease, you will hear static sound from the Speakers. This indicates that you have to replace the batteries. If left unattended, transmitter signal will be decreased until the Speaker NOISE MUTE function activates and shuts off all sound to the Speakers.
TROUBLESHOOTING If you follow all the instructions in this manual, you should have no problems with your Wireless Speaker System, However, in case you can not make the system work, please read the TROUBLESHOOTING section carefully. Do not return to your dealer immediately! Check and follow these guides you probably can resolve your problems without much difficulty.
SPECIFICATIONS TRANSMITTER Operating Frequency MHz Channel 1: L903.4 R926.6 Channel 2: 1902.6 R925.8 Channel 3: L904.2 R927.4 Power Sources a) AC Adapter {AC 120/60 Hz~DC 9V 200ma) Supplied bj DC four (4) x AA 15V Alkaline Batteries {Not Included) Transmitter Dimensions RECEIVER SPEAKER(S) & (H) x 31/4" Output Power 8 Watts Rms /Fer Channel Receiving Frequency Signal to Noise Ratio 55 dB Channel Separation. 25dB Distortion <2% Operating Range. Up To 125 Feet Speaker Elements 2 Tweeter, 5° Mid range range.