ADV10PS2 10.
Important Notice Installation of overhead products requires careful planning and preparation. Be extremely careful when working on a vehicle with side curtain air bags. Do not route wires near any portion of the side curtain air bag assemblies. This includes any anchor points in A, B, C or D pillars of the vehicle. Routing wires in these areas or running wires by the side curtain air bags can prevent the side curtain air bag from fully deploying which can result in personal injury to vehicle occupants.
FEATURES Congratulations Congratulations on your purchase of the ADVENT ADV10PS2 Player with Drop-Down Video / Monitor. The ADV10PS2 has been designed to give you and your family many years of video entertainment in the mobile environment. Please read the directions that follow to familiarize yourself with the product to ensure that you obtain the best results from your equipment.
QUICK START GUIDE 1. Insert batteries into the PlayStation2 game controllers and the remote control. Game controller transceivers are preinstalled when the unit is shipped. 2. Turn the vehicle on. Running this unit on battery power (accessory key setting) will drain the battery. 3. Press the screen release button to lower the LCD screen. Swing the screen back to allow the PlayStation2 to drop down. 4. Push the PlayStation2 release button to drop down the PlayStation2. 5.
QUICK START GUIDE (Cont) 11. When using the wireless headphones install the batteries in each headphone. Turn the volume to minimum before turning them on. Once they are turned on, place them on your head (pay attention to R/L earpieces) and slowly adjust the volume to a comfortable listening level. 12. When listening to the system over the vehicle radio: a. Using the remote control: i. to turn on the FM modulator by pressing FMM ON/OFF ii. Select an FM frequency by pressing FMM Select. iii.
QUICK START GUIDE (Cont) Using the Control Panel To access the Control Panel press the dark gray DISPLAY or dark gray SELECT button. The Control Panel (Below) can be used to navigate the DVD disc. Refer to figure below: Pressing the dark gray DISPLAY or dark gray SELECT button again will cause the Control Panel to change its position on the screen. Pressing the DISPLAY or SELECT button a third time will turn off the Control Panel. Use the dark directional buttons (q p u t ) to select an icon.
CONTROLS AND INDICATORS DIAGRAM (FRONT VIEW) 1. SOURCE Button (S) Use to select the sources: PS2, AV1 and AUX. 7 6 5 4 3 2 2. CURSOR Buttons (pqt u) Use these buttons to access menu selections on the screen. 1 3. MENU/ENTER Button Use this button to access SYSTEM MENU and select system menu items. MENU / ENTER 4. Infrared Transmitter and Sensor Transmits audio to wireless headphones, allows the remote control to operate the unit and to control other accessories in the system.
CONTROL FUNCTION DESCRIPTION (SIDE VIEW) 11. LCD Panel 12. Screen Release Press to release the screen. 1 2 13. LCD Cut Off Switch Used to turn off the LCD backlit when the LCD is in the closed position. 3 4 R AUDIO L VIDEO 14. OPEN Push to open the PlayStation2 tray. 15. OPEN () The disc tray opens. 1. HEADPHONE JACK For wired headphone with a 1/8” (3.5mm) plug. 16. RESET ( ) ON/Standby and RESET indicator. 2. Auxiliary Audio Right Input 3. Auxiliary Audio Left Input 4.
REMOTE CONTROL OPERATION MAIN FUNCTION OPERATION Back View OPEN/ CLOSE RESET P1 P36 AUDIO P2 P3 P4 P5 P6 P7 SHUFFLE 1 2 3 4 5 6 7 8 P35 ANGLE PROGRAM SUBTITLE REPEAT SLOW CLEAR SCAN PREV 9 TIME 0 P8 P9 PLAY NEXT PAUSE A-B STOP P10 DISPLAY TOP MENU MENU RETURN P11 P12 P13 Battery Cover P14 P15 P16 P17 P18 Battery Installation P19 P20 P26 P25 L1 L3 R3 R1 START L2 R2 MUTE SOURCE DISPLAY M1 M2 VOLUME FMM ON/OFF P24 P23 P22 P21 M11 M10 M9 PIX M3 FMM SELECT S
REMOTE CONTROL FUNCTIONS The remote control is divided into two sections, Dark Gray buttons on the top, which control the built-in PlayStaion2 and Light Gray buttons on the bottom of the remote control, that control the other functions of the unit. PLAYSTATION CONTROLS (P1-P37) (Dark Gray Buttons) NOTE: PlayStation2 controls (refer to the SONY PlayStation2 manual for details). P1. OPEN/CLOSE Not used on this model. P2. AUDIO Displays and changes DVD audio options. P3.
P8. SLOW ( / ) Changes to slow-motion playback. (Forward or Reverse) P9. SCAN ( / ) Fast forwards or fast reverses playback on the screen to locate a particular scene. P10. PLAY Starts playback. P11. DISPLAY Displays the Control Panel of the PlayStation2. P12. TOP MENU Displays the disc menu of DVD-Video discs. The content varies from disc to disc. P13. BUTTON: DVD MENU Selects the item to be changed. P14. ENTER Executes the item selected on the DVD disc menu or the on-screen Control Panel. P15.
P18. L1 BUTTON Previous (9), press to return to the previous chapter or track. P19. L2 BUTTON Search ( ) using fast reverse or fast forward playback. P20. SELECT Displays the control panel of the PlayStation2. P21. START Press to Play/Pause disc playback. P22. R2 BUTTON Search ( ) using forward playback. P23. R1 BUTTON Next (:) press to skip to the next chapter or track. P24. R3 BUTTON Displays Audio Options, press the language changes. P25. BUTTON: ENTER P26. BUTTON: CANCEL /<(Stop) P27.
P29. PAUSE Pauses and resumes playback. P30. STOP Stops playback. P31. PREVIOUS (9) / NEXT (:) Returns to the beginning of the current or previous chapter/Skips to the beginning of the next chapter. P32. A-B REPEAT Specifies a scene for playback and starts playback of the scene that has been set. P33. CLEAR Clears selected numbers or playback modes. P34. TIME Displays the current title or chapter number and the elapsed or remaining time. P35.
M2. MUTE Press this button to mute the audio. Pressing the button again restores the sound to the previously set level. M3. FMM ON/OFF Turns the wireless FM Modulator ON or OFF. M4. FMM SELECT Select the FM Modulator Frequency. M5. SYSTEM MENU Allows the user to access the main system menu for picture controls, FM Modulator Select, screen mode etc. M6. IR ON/OFF Turn Infrared Transmitter power ON/OFF for IR Wireless Headphones. M7.
WIRELESS CONTROLLER (2.4GHz) Carefully read the information before use. For detailed connection and usage methods, refer to the Owner’s Manual for the PIayStation2 system. HOW TO USE Battery Installation: The wireless controller uses two “AA” batteries. 1. Turn your controller upside down and remove the lid on the bottom by pressing against the lip and pulling the lid away. 2. Insert the battery as indicated in the controller. 3.
Sleep Mode: Your controller will automatically go into Sleep Mode after approximately three minutes if not used. The MODE LED indicator will go off. To reactivate the controller, you have a choice to press the START button or press down on one of the joy sticks on the controller. Your controller will automatically synchronize with the receiver in the PS 2 unit.
SYSTEM MENU ADJUSTMENT The System Menu contains features and options that let you customize your system to change the screen mode display, OSD language and source default. 1) 2) 3) 4) 5) 6) Press the MENU/ENTER button on unit to enter System Menu, the main page of the system menu will appear on screen. Use the cursor buttons p or q to select the desired item in the main page and press the MENU/ENTER button to select.
4) 5) 6) Use light gray t or u buttons to change the picture control setting. To change another picture control setting press the SYSTEM MENU button and select another picture control using the light gray p or q buttons. Repeat step 4 to change the picture control setting. To reset the picture control settings to the factory default settings, enter the picture control menu and use the light gray q button to highlight RESET and press the light gray ENTER button.
3) Press the light gray ENTER button on the remote control and the following screen will appear: 4) Use the light gray p (up) or q (down) arrow on the remote control to highlight FMM ON and press the light gray ENTER button to turn the FM Modulator on. FMM SELECT 1) Repeat steps 1 through 3 above and highlight FMM SELECT 2) Use the light gray q (down) arrow on the remote control to highlight FMM SELECT and press the ENTER button, the following screen will appear. FM M SELECT 88.1 M Hz 89.7 M Hz 88.
OSD LANGUAGE This allows the user to select the language for the on-screen display. The user can either select English, Spanish, French, German for the OSD language. SYSTEM MENU OSD LANGUAGE ENGLISH SPANISH FRENCH GERMAN PICTURE CONTROL FMM OSD LANGUAGE SOURCE DEFAULT PS2 SCREEN MODE SOURCE DEFAULT PS2 This allows the user to set the system default source to PS2 (via System Menu).
TURNING THE UNIT ON OR OFF 1. Pushing in the Screen Release button will unlock the LCD screen and it will drop down slightly. Pivot the screen downward until a comfortable viewing angle is reached. The hinge friction will hold the screen in position while the system is in use. 2. Pressing the power button* on the unit or the remote control will turn the system on and off. When in use the internal backlighting will illuminate the controls. 3.
OVERHEAD DOME LIGHTS The Dome Lights integrated into the unit are controlled by a three position slide switch. Sliding the switch to the ON position will turn the lights ON. The OFF position will prevent the lights from turning ON with the vehicle's interior lighting, and the auto position will allow the lights to turn ON and OFF with the vehicle's interior lighting. Refer to the Installation Guide for wire connections.
SOURCE FEATURE AV1 The AV1 input may be connected to a external video source, video game system, or other audio / video devices. To access the audio / video inputs, turn the unit on and press the S (source) button or the Source button on the remote control until "AV1" is displayed on the screen. Turn the video source component on with its power button or remote control and it is now ready to play the audio and video signals from the source connected .
TROUBLESHOOTING SOLUTION PROBLEM IR remote inoperative Verify that the batteries in the remote are fresh. Verify that the remote sensor eye is not obstructed. Disc won't play Insert a disc with the label side facing up. Check the type of disc you put into disc tray. This PS2 only plays PS2 GAMES, DVDs, audio CDs. Both the unit and the disc are coded by region. If the region codes don’t match, the disc can’t be played. Make sure screen source is set to PS2.
SOLUTION PROBLEM Not allowed at the moment The feature or action cannot be completed at this time because: 1. The disc’s software restricts it. 2. The disc’s software doesn’t support the feature (e.g., angles) 3. The feature is not available at the moment. 4. 4 title or chapter number that is out of range. Picture is distorted The disc might be damaged. Try another disc. It is normal for some distortion to appear during forward or reverse scan.
REPLACEMENT PARTS Remote Control SPECIFICATIONS 136-4926 LCD Backlighting LED Resolution 800 (RGB) x 480 Pixels 1,152,000 Operation Temperature 32 ~131º F (0 ~ 50º C) Storage Temperature -4 ~ 158º F (-20 ~ 70º C) Backlit life 10,000 Hours Video Display System NTSC / PAL Headphone Audio Output 0.03W @ 32 ohms Video Output 1.0Vp-p @ 75 ohms Power Source 12V DC Dimension LxWxH 12" x 12" x 2.5" 315mm x 315mm x 64.5mm Specifications subject to change without notice.
ADVENT LIMITED WARRANTY R Applies to ADVENT Mobile Video Products AUDIOVOX ELECTRONICS CORP. (the Company) warrants to the original retail purchaser of this product that, should this product or any part thereof (except game controllers), under normal use and conditions, be proven defective in material or workmanship within 36 months from the date of original purchase, such defect(s) will be repaired or replaced with reconditioned product (at the Company's option) without charge for parts and repair labor.
© 2010 ADVENT,150 Marcus Blvd.
