User Manual

LOM-15

102609

LOM-15

by EVOLVE GUEST CONTROLS

LOM-15

LOM-15 DUPLEX RECEPTACLE

The LOM-15 Duplex Receptacle is a component of the HomePro lighting control system. Wire the Duplex Receptacle in place of a standard

receptacle according to the diagram above and program from the Wireless Controller to operate loads. Inclusion of this Receptacle on

the IR-100 Wireless Controller menu allows remote ON/OFF control of loads connected to the controlled outlet. The other outlet remains

powered all the time.

This LOM-15 Duplex Receptacle is designed to work with other Evolve enabled devices. Evolve nodes of other types can be included

in the system and will also act as repeaters if they support this function of repeating the signal received, to other modules in the system.

This product supports 40Kbps data transmission. This product can also be used for networking support in systems that

stream metadata. An example might include transmission of information from audio devices such as song title, artist, and album information

to various displays around the home.

As part of a Evolve network, the LOM-15 will also act as a wireless repeater to insure that commands intended for another device in the

network are received. This is useful when the device would otherwise be out of the radio range of the wireless controller.

There are no field repairable assemblies on this unit. It is covered by a one year limited warranty. If service is needed, the unit must be

returned where purchased.

DANGER! SHOCK HAZARD. Read and understand these instructions before installing. This device is intended for installation in

accordance with the National Electric code and local regulations in the United States, or the Canadian Electrical Code and local regulations

in Canada. It is recommended that a qualified electrician perform this installation.

Make sure the total load controlled does not exceed 1800 watts. For indoor use only. Retain instructions for future use.

INSTALLATION

Wire this Receptacle in place of a current receptacle according to the diagram above. Use copper wire only, or the equivalent. See the

IR-100 Wireless Controller operating instructions to add this module under the command of the Wireless Controller.

INCLUDING LOM-15 TO THE NETWORK

STEP 1.. Prepare the Controller to include a unit to the network , by adding it to a group (method of adding a node to the network).

Refer to controller instructions.

Note: This module must be “Included in the Net-

work” only where it will be permanently

installed. The proper operation of this node in

the mesh network is dependent on it knowing its

location with respect to other nodes. You cannot

“test bench” configure this module, then install.

Radio Frequency Controlled, 120 VAC, 15A, Duplex

Receptacle, Rel. 2.1

Controlled Outlet

Always Powered

Outlet

PAGE 1
LOM-15 Radio Frequency Controlled, 120 VAC, 15A, Duplex Receptacle, Rel. 2.1 Always Powered Outlet Controlled Outlet Note: This module must be “Included in the Network” only where it will be permanently installed. The proper operation of this node in the mesh network is dependent on it knowing its location with respect to other nodes. You cannot “test bench” configure this module, then install. LOM-15 duplex receptacle The LOM-15 Duplex Receptacle is a component of the HomePro lighting control system.
PAGE 2
STEP 2. The LOM-15 must be in its permanently installed location. Tap the button on the face of the LOM-15 once when your controller indicates (to include in the network). STEP 3. You should see an indication on your Controller that the “device was included” in the network. NOTE: If you have trouble adding the LOM-15 to a group it may be that the Home ID and Node ID were not cleared from it after testing. You must first “RESET UNIT” with your controller to remove it from the network.
PAGE 3
Signal (Frequency) Range and/or the closest HomePro Module 908.42 MHz Up to 100 feet line of sight between the Wireless Controller Warranty For warranty and general product information visit our web site at www.eguestcontrols.com About LOM-15’s Certification The LOM-15 is certified to comply with applicable FCC and IC rules and regulations governing RF and EMI emissions. This device complies with part 15 of the FCC Rules.