PROFESSIONAL SERIES Owner’s Guide For Models: CA 4055 CA 4555 Vehicle Remote Start System IMPORTANT NOTE: The operation of the Security and Convenience System as described in this manual is applicable to most vehicles. However, due to the configuration of some vehicles, some functions AND/OR SAFETY PRECAUTIONS may not apply. Please see your installing dealer for more information. 2017 Voxx Electronics Corporation. All rights reserved.
Table of Contents Using Your Remote Starter...................................................................... 3 Remote Starting Your Vehicle............................................................. 3 Remote Start Shutdown..................................................................... 3 Unlocking the Vehicle (optional)......................................................... 3 Entering Your Vehicle while it is Running via Remote Start...............
Using Your Remote Starter Remote Starting Your Vehicle To activate the remote start function, press and release the button 2 times within 2 seconds. The system will sound, the parking lights will flash 1 time and the system will check the vehicle to ensure it is safe to start. If all safety parameters are correct, the vehicle will start. The vehicle’s parking lights will turn on (or flash depending on system settings) as a visual indication that the vehicle has started and is running.
Programmed Transmitter Notification - PTN As a security precaution each time the vehicle’s ignition is turn on the status LED light with flash the number of transmitters programmed into the system. This helps to identify unauthorized transmitters from accessing your vehicle. If you believe an unauthorized transmitter has been programmed to your system, contact your installing dealer for assistance.
Operating the 2 / 3 Hour Start Up Timer Mode The system has the ability to start the vehicle every 2 or 3 hours for a 48 hour period. This feature is especially useful in cold climates where the only means to keep the engine and engine fluids warm is to periodically start the engine. The default setting is 3 hour, selection between 2 or 3 hour is made in option programming. WARNING! Be certain that the vehicle is outdoors before using this or any remote starting device.
Remote Start Safety Features For safety and security reasons, the system will shutdown or prevent the remote vehicle starter from activating if any of the following occur: 1. The vehicle’s hood is open. 2. The brake pedal is pressed prior to turning the ignition key to the ON position. 3. The engine is over-revved (tach checking only). 4. Valet Mode is active.
Remote Control Buttons & Functions 1 Button Transmitter Start Operation Method Remote Start X Press and Release 2 times Unlock X Press and Release 2 times - During remote start only Remote Start Shutdown X Press and Hold (3 Sec) 2 / 3 Hour Start X Ignition On/OFF, Press and Hold Valet Button, press and release Start 4 times Car Find X Press and Hold (3 Sec) - Ignition OFF/vehicle not running 2 Way Remote Control Notifications - ca4555 Only FUNCTION BEEPS / LED FLASHES Activat
Replacing Remote Control Batteries 1 Way Remote Control, CAT1B: The battery (model CR2032) inside each remote control should last approximately 1 year under normal use. When the battery becomes weak you will notice the remote control range (the distance from the vehicle the remote control will work) deteriorate and the small LED on the remote control will dim. To replace the battery in the remote control: 1. Unsnap and disassemble the halves of the remote control. 2.
LIMITED LIFETIME WARRANTY Applies to Code Alarm Series Control Modules, Sirens, Sensors, and Relays.
ca4055 - ca4555 Owners
2017 Voxx Electronics Corporation. All rights reserved.
Voxx Electronics Corporation. Customer Service 1-800-421-3209 WWW.CODE-ALARM.COM FCC COMPLIANCE This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including any interference that may cause undesired operation.