User's Manual

ManualsBrandsAdvance Multimedia Internet Technology ManualsComputers & AccessoriesWiFi Mobile Broadband Router

Advance Multimedia Internet Technology Inc.

No.28, Lane 31, Sec. 1, Huandong Rd., Sinshih Township, Tainan County 74146, Taiwan

CDM530NC

WiFi Mobile Broadband Router

Installation Steps

Step 1. Install the battery:

Turn OFF the power switch, open the battery lid, and

then insert the Li-ion battery into the battery holder.

DO NOT insert or remove the Li-ion

battery while the power switch is at

ON position.

Step 2.

Close the battery lid

Step 3. Plug in power:

Connect with the power adapter to the receptor on the

back panel of it.

Summary of content (8 pages)

PAGE 1
Advance Multimedia Internet Technology Inc. No.28, Lane 31, Sec. 1, Huandong Rd., Sinshih Township, Tainan County 74146, Taiwan CDM530NC WiFi Mobile Broadband Router Installation Steps Step 1. Install the battery: Turn OFF the power switch, open the battery lid, and then insert the Li-ion battery into the battery holder. DO NOT insert or remove the Li-ion battery while the power switch is at ON position. Step 2. Close the battery lid Step 3.
PAGE 2
Step 4. Start to Charge the Battery: Then plug the other end of the power adapter into a wall outlet. If it is the first time to put the battery in, the power LED will show amber which means the battery is been charging. It will take about 3 hours to fully charge the battery, and when the battery is fully charged, the power LED will show green. Step 5. Power ON: Turn ON the power switch. ON Step 6.
PAGE 3
Chapter 1 Getting Started with Easy Setup Utility There are two approaches for you to set up the WiFi Mobile Router quickly and easily. One is through executing the provided Windows Easy Setup Utility on your PC, and the other is through browsing the device web pages and configuration. 2.1 Easy Setup by Windows Utility Step 1： Install the Easy Setup Utility from the provided CD then follow the steps to configure the device. Step 2： Select Language then click “Next” to continue.
PAGE 4
Step 5： Select Wireless Enable, and then click “Next” to continue. Step 6： Enter SSID, Channel and Security options, and then click “Next” to continue. Step 7： Select 3G Service by clicking 3G icon to continue.
PAGE 5
Step 8-1： Select “Auto-Detection”, and the Utility will try to detect and configure the required 3G service settings automatically. Click “Next” to continue. Step 8-2： Or you can select “Manual” and manually fill in the required 3G service settings provided by your ISP. Click “Next” to continue. Step 9： The WiFi Mobile Router is rebooted to make your entire configuration take effect.
PAGE 6
Step 10： Click “Next” to test the Internet connection or you can ignore test. Step 11： Click “Next” to test WAN Networking service. Step 12： Setup is completed.
PAGE 7
PAGE 8