Declaration of Conformity

Declaration of Conformity for PUCK 3.1
Hereby, Sony Mobile declares that the equipment type PUCK 3.1 is in compliance with
Directive: 2014/30/EU. The full text of the EU declaration of conformity is available at
the following internet address: http://www.compliance.sony.de/
Manufacturer: Sony Mobile Communications Inc, 4-12-3 Higashi- Shinagawa,
Shinagawa-ku, Tokyo, 140-0002 Japan.
For EU product compliance: Sony Belgium, bijkantoor van Sony Europe
Limited, Da Vincilaan 7-D1, 1935 Zaventem, Belgium.
FCC Statement
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
Any change or modification not expressly approved by Sony may void the user's
authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device should be installed and operated with minimum distance of 20cm from the
human body.
Industry Canada Statement
CAN ICES-3(B)/NMB-3(B)
This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to
the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
This device should be installed and operated with minimum distance of 20cm from the
human body.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d'en compromettre le fonctionnement.
Cet équipement doit être installé et utilisé avec un minimum de 20cm du corps humain.
Supported frequency bands:
Bluetooth Low Energy 2.4GHz (Power Class: <10mW)
NFC 13,56 MHz