User's Manual

WCI Instructions 07.09
ADURA TECHNOLOGIES™
San Francisco, CA 94105
Tel: [phone] • Toll Free 1-888-828-8281
ADURA TECHNOLOGIES™
San Francisco, CA 94105
Tel: [phone] • Toll Free 1-888-828-8281
w w w . a d u r a t e c h . c o m
wall control interface
INSTALLATION
INSTRUCTION MANUAL
The Wall Control Interface is to be used to control lighting in commercial and industrial
buildings. It is to be installed with a low voltage wall switch in place of a conventional
line voltage wall switch. When an occupant presses the wall switch, the Wall Control
Interface transmits the occupant’s request for more or less lighting via radio frequency.
The Wall Control Interface is intended to be used in a network of devices which
communicate wirelessly, such as Light Controllers, occupancy sensors and software
management tools.
The Wall Control Interface mounts inside an electrically rated junction box behind a UL
listed wallplate. Often, the Wall Control Interface will be mounted in an existing junction
box that was previously used for one or more wall switches. The Wall Control Interface is
designed to screw into standard gang box mounting holes. There is a 30 second
If your installation requires mounting in an alternate size junction box, please contact
ADURA’s technical support. The Wall Control Interface is designed to work with a low
voltage wall switch such as a Leviton® model 56081-2.
TM TM
CAUTION
• Disconnect all incoming power before installation or service.
• The Wall Control Interface must be installed in accordance with state, local and national
electrical codes and requirements.
Input Voltage:
Power Consumption:
Radio Frequency:
RF Transmission Output Power (Average):
120 or 277 VAC
0.5 mA
2.4 GHz
+12 dBm
40 to 120 deg F, dry location
Dimensions:
Operating Environment:
stored in non-volatile memory
Mounting:
Wires: 9" 600 VAC rated, 18 AWG solid conductors
See drawing
Installation Materials (Not Supplied)
Wiring connectors. All existing wiring connectors must be replaced with new UL listed
wiring connectors, either wire nuts or captive-type connectors. All wiring connectors must
be correctly sized for the application, the number and the size of the electrical conductors.
WARRANTY INFORMATION
Adura Technologies
™
repair or replace any product that is defective in materials or manufacture that is returned to ADURA within the warranty period. This
warranty is void if this product has been installed improperly or in an improper environment, overloaded, misused, or altered in any
manner, or not installed in accordance with any labels or instructions. Adura Technologies is not liable for incidental, indirect,
warranty does not cover the cost of installation, removal or reinstallation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful Interference when the equipment
is operated in a commercial environment. The equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful interference to radio communica-
tions. Operation of the equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his/her own expense.
Class A Digital Devices
maintained between the antenna of this device and all persons. This device must not be co-located or operating in conjunction with
any other antenna or transmitter.
Ordering Information:
Mounts in a double gang box. Requires a switch
plate with a decorator opening and a blank
WCI
Wall Control Interface
Model Number
Description
Kit with WCI and ivory decorator switch
WCI Kit-I
WCI Kit-W
Kit with WCI and white decorator switch