FCC ID: P27SCB1R0 SCB1R0-29xxxxx(the 1st x should be "blank" or "-"; the rest x could be 0 to 9, A to Z, a to z, "blank" or "-", for the marketing purpose) Camera Hub (WiFi Extender) i
FCC ID: P27SCB1R0 User Guide Table of Contents CHAPTER 1 INTRODUCTION.............................................................................................. 3 Package Contents .............................................................................................................. 3 Features .............................................................................................................................. 3 LEDs ........................................................................
FCC ID: P27SCB1R0 Chapter 1 Introduction 1 This Chapter provides an overview of the Camera Hub’s features and capabilities. Congratulations on the purchase of your new Camera Hub (WiFi extender). The WiFi extender is a consumer electronic device, which is designed to extend the WiFi signal for all appliances of your home, major from IP cameras, and video doorbells. It allows you to increase WiFi speed and range by taking the signal from a home router and retransmit to the furthest corner of your house.
FCC ID: P27SCB1R0 LEDs Front Panel The Camera Hub has 4 LEDs.
Appendix B - About Wireless LANs Rear/Side Panel Power Plug Connect the power plug to a wall socket. Reset This button has two (2) functions: • Reboot. When pressed and released, the Camera Hub will reboot (restart). • WPS Button Clear All Data. This button can also be used to clear ALL data and restore ALL settings to the factory default values. To Clear All Date and restore the factory default values: 1. Power On. 2. Keep holding the Reset Button down for 3 seconds. Release the Reset Button.
FCC ID: P27SCB1R0 Chapter 2 Initial Installation 2 This Chapter covers the device installation of the WiFi extender. Requirements • None of cables required for the installation. Procedure 1. Choose an Installation Site Select a suitable place to install the Camera Hub. 2. Power Up Place the extender near the existing router. Provide the power to the extender so plug it into a wall socket or a power strip.
Appendix B - About Wireless LANs Chapter 3 Configuration 3 This Chapter provides Setup details of the WiFi extender. Configuration The WiFi extender can offer customers with extending wireless communication between devices and the router wherever at home. This extender is designed to provide reachable network connection with all certified devices especially for IP cameras, security doorbells and other WiFi devices. Configuring WiFi extender via WPS Button In this case, make sure an existing router.
FCC ID: P27SCB1R0 Appendix A Specifications A Camera Hub Model Camera Hub (WiFi Extender with Chime) Dimensions 130mm (H) x 128mm (W) x 72mm (D) Operating Temperature 0°C - 40°C (32°F - 104°F) Buttons 2 (1 Reset, 1 WPS button) Network Protocol: TCP/IP, 802.11 b/g/n Bluetooth 4.
Regulatory Approvals FCC Statement Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
FCC ID: P27SCB1R0 ● FCC RF Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.