User's Manual

ManualsBrandsAdomax Technology ManualsComputers & AccessoriesWireless Mouse

FCC ID: MNL160020021025

AM 1600 Manual

The Federal Communication Commission Statement

This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in

accordance with the instruction, may cause harmful interference to radio

communication. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and receiver.

 Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

 Consult the dealer or an experienced radio/ TV technician for help.

Changes or modifications not expressly approved by the party responsible

for compliance could void the user‘s authority to operate the equipment.

Use only shielded cables to connect I/O devices to this equipment.

You are cautioned that change or modifications not expressly approved by the

party responsible for complies could void your authority to operate the

equipment.

THIS DEVICE COMPLIES WITH PART 15 OF FCC RULES. OPERATION IS

SUBJECT TO THE FOLLOWING TWO CONDITION:

(1) This device may not cause harmful interference and

(2) This device must accept any interference received, including interference

that may cause undesired operation.

Welcomed!

Thank you for purchasing this RF Wireless Optical Mouse. Utilizing the latest

wireless RF technology, this mouse can work from any directions or angles

even when objects hinder between your mouse & the receiver. You can

locate the device freely and enjoy its convenience.

Summary of content (5 pages)

PAGE 1
FCC ID: MNL160020021025 AM 1600 Manual The Federal Communication Commission Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communication.
PAGE 2
Install Your Wireless Mouse Hardware Installation Installing Batteries 1. Remove the battery cover from the bottom of your mouse. (1)（Press down the lid on the bottom of the mouse） (2)（The top shell pops out automatically. Push forward the top shell.） 2. Insert two AA Alkaline Batteries into the battery compartment. 3. Replace the cover carefully. Once the battery is placed correctly in the mouse, the optical LED located at the mouse bottom will light up.
PAGE 3
For 800 cpi mouse 1. After you insert the receiver to your computer, the LED of the receiver will flash slowly; 2. Press the reset button on the back of your mouse in 3 minutes; reset button 3. Once the receiver link with the mouse successfully, the LED of the receiver will blink quickly. If the reset button was not pressed within 3 minutes after the receiver is connected, please relocate the receiver and press the reset button again within 3 minutes.
PAGE 4
3. Universal Scroll: Control the directions and speed of scrolling bar by moving your mouse. You can set up the vertical or horizontal scrolling directions and speed. 4. Universal Zoom: Magnify or minimize any characters or illustrations. You can adjust the zoomed area or zoom factor by pushing the wheel forward or backward. 5. Auto Scroll: Move the mouse once in the direction you want to scroll. 6. Horizontal Wheel: You can press the wheel button to change the scroll direction from vertical to horizontal.
PAGE 5
* Battery detection system and middle wheel indicator light warn you when the battery power is low and requires replacement. Mouse Software Un-installation 1. Click Start on the Taskbar and select PERFECT SERIES from Program Files. 2. Please choose “Uninstall RF Wireless Optical Mouse and follow the on-screen instructions.