Setup Guide

ManualsBrandsAdemco ManualsElectronicsIndoor Motion Viewer

PROINDMV Indoor Motion Viewer

Installation and Setup Guide

General Information

The PROINDMV is a battery powered, wireless indoor motion detector with a built-in video camera designed for

use with Honeywell Home Security Systems. The detector is powered by 3 CR123A Lithium batteries that

provide up to 4 years of battery life.

NOTE: Installation shall be done in accordance with the National Electrical Code, NFPA 70.

Features

• No wiring or remote power required. Fully portable battery powered camera allows for ﬂexibility in selecting

locations

• Provides video stream and live video viewing functionality

• Spread Spectrum, Interactive, AES Encrypted Wireless technology provides optimum signal integrity and security

• CMOS camera sensor with a wide angle 90° lens

• Night vision with one white LED

• Fresnel lens motion detection: 39.37ft (12m) 90° detection pattern

• Camera sends color video

Installation Guidelines

Programming and RF testing should be done while the device is in its intended mounting location to ensure good communication

between the control panel and the device.

Mounting Considerations

• Use proper tools and hardware.

• Mount indoors in a temperature-controlled

environment.

• Mount camera 7.5ft (2.3m) above the floor.

• Do not aim detector at windows, especially

those that let in direct sunlight, or at heat

sources such as fireplaces, radiators and

heating vents.

• The detector should be installed opposed

to an access mount or asset you need to

protect.

• Do not aim detector at moving objects

such as fans.

• Do not paint or cover the detection or

camera lens.

Mounting (Open/Close) the PROINDMV

1. Separate the rear case/wall mount from the PROINDMV by pressing the latch on the bottom of the case and rotating out.

2. Secure the rear case/wall mount in the desired location with the two provided screws (See Mounting Options section below).

NOTE: MUST be mounted on a stud, solid wall, or with a robust wall anchor.

3. Slide the PROINDMV onto the rear case/wall mount bracket.

Summary of content (4 pages)

PAGE 1
PROINDMV Indoor Motion Viewer Installation and Setup Guide General Information The PROINDMV is a battery powered, wireless indoor motion detector with a built-in video camera designed for use with Honeywell Home Security Systems. The detector is powered by 3 CR123A Lithium batteries that provide up to 4 years of battery life. NOTE: Installation shall be done in accordance with the National Electrical Code, NFPA 70. Features • No wiring or remote power required.
PAGE 2
Mounting Options NOTE: Before mounting permanently, conduct a Sensor Walk Test (see the controller’s instructions) to verify adequate signal strength and adjust the device location and orientation as necessary. The PROINDMV can be mounted on the wall or in corners: • [A] = Wall Mounting Holes • [B] = Corner Mounting Holes • The rear tamper plate MUST be mounted to a stud, sold wood, or with a robust wall anchor.
PAGE 3
Walk Testing After power up and enrollment, activate the Walk Test Mode with the controller. Walk Test mode is entered/exited through “Tools” menu of the control panel. Select the Test mode to make the PROINDMV enter Walk Test. NOTE: The system must be disarmed. The system can only be armed after exiting the Walk Test mode. Replacing the Batteries Use only Resideo 300-09028, DURACELL DL123A or PANASONIC CR-123A, CR-123APA/B, CR123PE/BA batteries. BATTERY CAUTION: Risk of fire, explosion and burns.
PAGE 4
Physical properties Dimensions ....................................................................................................................................................................................................... 4.92 x 2.05 x 1.81 in (125 x 52 x 46mm) Weight ................................................................................................................................................................................................................... 5.82 oz.