User Manual

ADCP-75-158 • Preliminary Issue A • June 2003 • Section 4: Operation

Page 4-4

Figure 4-1. Digivance Element Management System Main Window

9. Open the View drop down menu and connect to the Host and Remote pair by selecting

“NotNamed/NotNamed”. The HOST Alarms display and the REMOTE Alarms display

will open within the main window as shown in Figure 4-2.

10. Verify that the Host and Remote Unit are loaded with the current system software and

download the current software to both the Host and the Remote unit if necessary. Refer to

Section 2.2 for details.

Figure 4-2. Selecting Display Tabs

Click to view drop

down menu

Clicking on the tabs in

this list will open the cor-

responding display.

Host/Remote pair

site name

FCC ID: F8I-DLC1902A

PAGE 1
FCC ID: F8I-DLC1902A ADCP-75-158 • Preliminary Issue A • June 2003 • Section 4: Operation Click to view drop down menu Figure 4-1. Digivance Element Management System Main Window 9. Open the View drop down menu and connect to the Host and Remote pair by selecting “NotNamed/NotNamed”. The HOST Alarms display and the REMOTE Alarms display will open within the main window as shown in Figure 4-2. 10.
PAGE 2
ADCP-75-158 • Preliminary Issue A • June 2003 • Section 4: Operation 11. Click on the HOST Config tab and on the REMOTE Config tab (see Figure 4-2). The HOST Config display and the REMOTE Config display will open within the main window. 12. Enter the Site Name and Site Number for both the HOST and the REMOTE unit. Refer to Section 2.4 for details. 13. If the site has multiple host units, reconnect the CAN cables to the HU’s NET IN and NET OUT ports. 14.
PAGE 3
ADCP-75-158 • Preliminary Issue A • June 2003 • Section 4: Operation 2.2 Verify/Download HU and RU System Software The HU’s and RU’s may require a system software download if they are not loaded with the current system software. Use the following procedure to check the version number of the system software and if necessary to download the current system software: 1. Click on the HOST Prg Load tab and on the REMOTE Prg Load tab.