User's Manual

USER MANUAL

FOR (KSC-TXF) KELVIN SINGLE-USE CELLULAR TEMPERATURE DATALOGER

When you purchase ADAPT’s KELVIN SINGLE-USE CELLULAR TEMPERATURE Datalogger product (KSB-TXF)

- it is in PRE-REC mode by default, off the shelf.

1. PRE-REC MODE: This is the initial state of the Datalogger, it means that the datalogger is currently

un-used and is ready to START recording whenever initiated by the user. Visually you can identify that

a datalogger is in PRE-REC mode, by finding that the display does not show any REC or END icon at

the top.

On Single Click : Click on the button once – to turn the display ON &

view its current temperature reading.

The device also tries to connect to the internet & send data to the

server.

2. START RECORDING: When you need the datalogger to START

recording temperature –

Allow the Display to turn off, then press & hold the button on

the device for atleast 3 seconds until the REC icon starts

blinking on the display.

3. REC-DELAY MODE : Once ‘Start Recording’ is

instructed by pressing the button for 3 seconds,

the Datalogger is programmed to delay the

recording.

This delay allows the Datalogger to settle to its

environmental temperature and prevent unwanted

temperature violations.

The display turns ON & shows :

- A blinking REC Icon – indicating REC-DELAY Status.

- Its current temperature reading. (in deg Cel)

- Delay Interval Countdown (in Minutes)

- The device also tries to connect to the internet & send data to the server.

4. REC MODE : After the delay interval – the Datalogger starts logging the temperature every 10

minutes. This state means that the datalogger is currently logging temperature. Visually one can

identify that a device is in REC mode, when the display shows a Static REC icon at the top.

The display turns ON & shows :

- A Static REC Icon – indicating REC Status.

- Its current temperature reading. (in deg Cel)

- Delay Interval Countdown (in Minutes)

- The device also tries to connect to the internet & send data to the server.

- Bell Icon to indicate Violation Alarm (if any)

ACTION

STATUS

PAGE 1
USER MANUAL FOR (KSC-TXF) KELVIN SINGLE-USE CELLULAR TEMPERATURE DATALOGER STATUS When you purchase ADAPT’s KELVIN SINGLE-USE CELLULAR TEMPERATURE Datalogger product (KSB-TXF) - it is in PRE-REC mode by default, off the shelf. 1. PRE-REC MODE: This is the initial state of the Datalogger, it means that the datalogger is currently un-used and is ready to START recording whenever initiated by the user.
PAGE 2
ACTION SCREEN WITH NO VIOLATION INDICATION SCREEN WITH VIOLATION INDICATION 5. STOP RECORDING: When you need the datalogger to STOP recording temperature – press & hold the button on the device for atleast 3 seconds until the END icon starts blinking on the display. 6. END MODE : Once ‘Stop Recording’ is instructed by pressing the button for 3 seconds - the Datalogger enters END Mode. Visually you can identify that a datalogger is in END mode, by finding that the display shows an END icon at the top.
PAGE 3
7. GENERATE & DOWNLOAD REPORT : Login to the KELVIN Web app with your credentials. Goto the ‘Reports’ Section. Search the particular Device Id & Download the PDF report. Adapt Loggers, Third floor, Nasuja Building, Shilpi valley, Madhapur, Hyderabad, Telangana, India. Pin-500081 www.adaptloggers.com Contact: Shiva (+91 86397 39890) FCC Caution. This device complies with part 15 of the FCC Rules.