User's Guide

The ILLUMRA

PIR Motion Sensor detects motion and links directly to controllers such as the

ILLUMRA

LED Dimmer, ILLUMRA

ON/OFF Controllers, etc. The ILLUMRA

PIR Motion Sensor

offers hands-free convenience by turning lights On when entering closets, bathrooms, and

other areas and saves energy by automatically turning lights OFF after an adjustable timeout

when no motion is detected. An integrated light sensor can be congured to keep lights off

when natural light is available.

INSTALLATION

Thanks to its shape and the included accessories, you can install your PIR Motion Sensor

anywhere in your house.

On your desk On your wall On your ceiling

ON YOUR WALL

a Use a screw to hang your sensor on the wall.

b Stick your sensor on the wall with the double sided tape.

c Screw the support on the wall to mount your sensor on it.

ON YOUR CEILING

d Drill a 45mm diameter hole in thin ceiling to insert the included fastening hooks and mount

the support in them.

e Mount your sensor into the support.

Part Number: E9T-OBP

Power supply: battery CR123A 3V

Lifetime: 5 years

Radio frequency: 902 MHz

RF power Max: +3dBm

Wireless range: Up to 30 meters

Detection range: Up to 5 meters

Lux sensing: 0 to 1000Lux

Operational temperature: -10°C / 45°C

EEP (Prol EnOcean

): A5-07-03

Dimensions: 65 mm (l) x 65 mm (L) x 39 mm (h)

Weight: 54 g

Warranty: 2 years

USER GUIDE

PIR - MOTION SENSOR

(10ft)

5m (16ft) 5m (16ft)

(16ft)

2.3m

(8ft)

PAGE 1
USER GUIDE The ILLUMRA® PIR Motion Sensor detects motion and links directly to controllers such as the ILLUMRA® LED Dimmer, ILLUMRA® ON/OFF Controllers, etc. The ILLUMRA® PIR Motion Sensor offers hands-free convenience by turning lights On when entering closets, bathrooms, and other areas and saves energy by automatically turning lights OFF after an adjustable timeout when no motion is detected. An integrated light sensor can be configured to keep lights off when natural light is available.
PAGE 2
AUTO OFF-TIME SETTING REPLACING THE BATTERY In order to replace the battery, open the product following the below instructions. Please, make sure you don’t touch the sensing part located in the middle of the circuit board. Auto off-time 30sec 5min 15min 30min Number of press after glowing 1st press 2nd press 3rd press 4th press LED blinks 1 2 3 4 « Setting » Mode will automatically exit and the setting saved, after no action on the button for 5sec.