@ ACUMEN Acumen Wall Mount Programmable Model H TR Fireplace Remote Control .
1 1 .0 Installation Instruction .1 Installing the Receiver WARNING: TURN ELECTRICAL POWER OFF AT THE CIRCUIT BEAKER BEFORE BEGINNING THIS INSTALLATION. 1. 3. Connect the electrical service wires to the junction box of the fireplace. Place the receiver onto the base pan of the fireplace. Connect the wires labeled * Main Valveā to the Millionth generator and Millionth valve (see Fig.1) or the Emergency Switch (Fig.2). Switch the Emergency Switch to OFF position if it is installed.
Figure 5 Figure 7 2.0 Operation Instructions: 2.1 Transmitter Operation The Wall Mount Programmable Model L Remote Control has 2 operating modes. They are: System ON and Manual on/off. 2.44 1. ob WN 21.2 Program the Thermostat Press the Prof INT button and then use the Up or Down buttons to choose NO and Press the Enter button to skip adjusting clock. Choose NO again (if necessary) to skip Vacation Override. Then Choose YES for programming the thermostat.
the target temperature. 4. Use the Up or Down buttons to adjust the set temperature. 5 Press Manual Bellybuttons to turn off the fireplace (if it is already on) and exit Manual Mode. WARNING: IT TAKES SOME TIME FOR THE RECEIVER TO RESPOND TO THE TRANSMITTER.DO NOT PRESS THE MANUAL ON/OFF BUTTONS MORE THAN ONCE WITH 2 SECONDS FOR CORRECT OPERATION. 243 Vacation Override 1. Vacation Override can be activated to save energy when you are away.
6. Use fresh alkaline batteries only. WARNING: THE REMOTE TRANSMITTER WILL AUTOMATICALLY SWITCH OFF THE FIREPLACE WHEN THE BATTERIES IN THE REMOTE TRANSMITTER 1S LOW. 3.0 IMPORTANT SAFETY FEATURE: You can set a private code into your system to prevent accidental operation by another transmitter nearby. See Fig.8. 3.1 Coding Instructions: 1. 2 eons There are code switches at the back of the Remote Transmitter. Slide the code switches to you choice of ON or OFF positions.