User's Manual

Acumen Wall Mount WMT103
Fireplace Remote Control
Installation and Operation Instructions:
The Acumen Wall Mount WMT103 Remote Control is designed for use with decorative gas fireplace and wall
heaters using SIT 825 Nova gas valve.
The Wall Mount WMT103 Transmitter is a six-button transmitter, which turn the gas on/off or as a thermostat.
The display of the transmitter shows the clock, current room temperature, target temperature, timer setting,
on/off status and low battery indicator.
Installation Precautions:
The Wall Mount WMT103 Remote Control is tested safe when installed in accordance with this installation
manual. It is your responsibility to read all instruction before starting installation and to follow these
instructions carefully during installation.
The Wall Mount WMT 103 Remote Control MUST be installed by a qualified service technician.
The Wall Mount WMT 103 Remote Control is carefully engineered and MUST be installed only as specified. If
you modify it or any of its components, you may possibly cause a fire hazard.
FCC Requirements
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 to the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
– Reorient or relocate the receiver antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
– Consult the dealer or an experienced radio TV technician for help.
Canadian Equipment Requirements
This digital apparatus does not exceed the (class A/Class B)* limits for radio noise emissions from digital
apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications. Le
present appareil numerique n’emet pas de bruits radioelectriques depassant les limites applicables aux
appareils numeriques (de la class A/de la class B)* prescrites dans le Reglement sur le brouillage
radioelectrique edicte par le ministere des Communications du Canada.
This device complies with RSS-210 of Industry Canada. Operation is subject to the following two conditions :
(1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
All wiring should be done by a qualified electrician and shall be in compliance with local codes and with the