API7220 Technical Specifications V 0.
1. Overview This document specifies the hardware features and requirements for ACTIONTEC API7220 11ax 2x2 indoor AP. Model Enclosure API7220 AM2 Features o o o o o o o o o o o o o o o o o Chipset: IPQ6000; 5G radio: QCN5052 a/n/ac/ax, 2x2 , 1.2Gbps; 2.4G radio: QCN5022 b/g/n/ac/ax , 2x2, 574Mbps; 1x BLE5.
4. Hardware feature 11-1 Interfaces 2 x GbE Port 1-1a 1 x GbE WAN with PoE 1-1b 1 x GbE LAN 1-2 1-3 1 x Reset Button DC jack 33-1 WIFI feature Frequency 2.4GHz 5GHz 3-2 3-3 Antenna Channel Rate 1 x RJ-45 for 10/100/1000M Ethernet port; Supports IEEE 802.3at PoE, as an isolated defined PD; The Ethernet port shall be compatible with the physical layer interface spec defined in 802.3 series. Up to 100 meters of CAT5e or above cable.
- Power 4-1 AP can be powered from 802.
Federal Communications Commission (FCC) Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generate, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
ISED CAN ICES-003 (B)/NMB-003(B) Canadian Compliance Statement This device complies with Industry Canada license-exempt RSSs. Operation is subject to the following two conditions: 1. This device may not cause interference, and 2. This device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
5. Produits DFS (Dynamic Frequency Selection) fonctionnant dans les bandes de fréquences 5250-533 MHz, 5470-5600 MHz et 5650-5725 MHz. IMPORTANT NOTE: Radiation Exposure Statement: This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.