MiniPCI 802.
Contents 1. Contents 2. Introduction 3. Bluetooth Basics 4. Installation Overview 5. Federal Communication Commission Interface Statement 6.
2. Introduction Thank you for purchasing MiniPCI 802.11b/g wireless lan Module. This manual will assist you with the installation procedure. The package you have received should contain the following items: • Mini PCI 802.11b/g Wireless LAN Card • User manual • CD containing Wireless LAN Management utility and driver software.
3. MiniPCI 802.11b/g Wireless Lan Card Basics Wireless systems offer a great number of advantages over a traditional, wired system. MiniPCI Wireless LAN Card are more flexible, easier to setup and manage and often more cost effective than their wired equivalence. With Mini PCI wireless LAN Card users can access shared information without looking for a place to plug in and network managers can set up or augment networks without installing or moving wires.
4. Installation and Overview Here are some steps you will perform in establishing your wireless network connection: 1. Install Atheros Utility using the Installation CD. 2. The Installshield Wizard will showed up 3.
4. The “Atheros Client Installation Program” will show up, please click Next. . 5. Please click I accept the terms of the license agreement.
6. Recommended you to click Install Client Utilities and Driver and then click Next 7. Please click Yes to continue.
. Please click Browse to find the Atheros driver destination location. And then click Next 9.
10. Wait, while Setup is performing the request operations. 11.
12.
13. If you install the driver successfully. The Atheros Icon will be showed up. 14. You could double click the Atheros Icon to check the Signal Strength.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Statement Actiontec declares that US model of 802MAG, ( FCC ID: LNQ802MAG ) is limited in CH1~CH11 for 2.4 G band by specific firmware controlled by the manufacturer and is not user changeable.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna, 3) For all products market in US, OEM has to limit the operation channels in CH1 to CH11 for 2.4G band by supplied firmware programming tool. OEM shall not supply any tool or info to the end-user regarding to Regulatory Domain change.
