Falcon Hardware Specification Model: V3.
Contents 1 Introduction ....................................................................................................................... 3 2 Main Characteristics........................................................................................................ 3 3 Electrical Characteristics ................................................................................................ 3 4 Dimensions .........................................................................................
1 Introduction This specification describes properties and notice of the wireless transmission module made by Falcon. 2 Main Characteristics No. Parameter Characteristics 1 Frequency 2.4GHz 2 Band width 10MHz (uplink), 10MHz(downlink) 3 Power 25dBm(Ground Unit), 25dBm(Air Unit) 4 Modulation OFDM 5 Constellation BPSK, QPSK 6 FEC LDPC (1/2, 2/3, 3/4, 5/6) 7 Duplex TDD 8 Downlink throughput 2.08Mbps ~ 6.
5 6 7 Unnecessary out-of-band uW/M - 2.
4 Dimensions Fig.
5 Connector Pins Definition Name Pin Type Description PWR 1,2 PI Power input(12V±5%，2A) GND 7,8 - UART1_TX 5 DO/NP UART1 transmit UART1_RX 6 DI/PU UART1 receive UART2_TX 3 DO/NP UART2 transmit UART2_RX 4 DI/PU UART2 receive FEA_TDP 9 AIO/PU Ground Ethernet in/out differential positive signal of interface 1 FEA_TDN 10 AIO/PU Ethernet in/out differential negative signal of interface 1 FEA_RDP 11 AIO/PU Ethernet in/out differential positive signal of interface 2 6 /
FEA_RDN 12 AIO/PU Ethernet in/out differential negative signal of interface 2 6 Notice 1) During mounting ●Please do not use metals for a chassis setting this module. ●Please do not mount parts under this module except a specified connector. 2) During operation ●The products might receive the radio wave interference from electronic devices such as Wireless LAN devices, Bluetooth devices and so on that radiate electromagnetic wave.
●For long-term storage, place the product in a well-ventilated condition at 10°C ~50°C, with a relative humidity below 85%. FCC Statement: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
List of applicable FCC rules This module has been tested and found to comply with Part15C, Section 15.247 requirements for Modular Approval. End Product Labeling This transmitter module is authorized only for use in device where the antenna may be installed such that 20cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: “Contains FCC ID: 2A8JK-FIDESLINK”.
As long as all conditions above are met, further transmitter test will not be required. However, the OEM integrator is still responsible for testing their end-product for any additional compliance requirements required with this module installed. Manual Information To the End User The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the user’s manual of the end product which integrates this module.
