Product Name Version Date AI7697H MT7697 IoT SiP Module A Feb 21, 2017
1. Description AcSiP Technology Corp. introduces a low-cost and low-power consumption IoT module. This stand-alone module is an operating system designed for wearable or internet of things (IoT) devices with smart connection and cloud application/services. AI7697H is a highly integrated SIP module which features an application processor, a low power 1x1 11n singlw-band Wi-Fi subsystem, a Bluetooth subsystem, and a Power Management Unit.
Dual-band 1T1R mode with data rate up to 150Mbps Supports STBC, LDPC Greenfield, mixed mode, legacy modes support IEEE 802.11 d/e/h/i/k/r/w support Security support for WFA WPA/WPA2 personal, WPS2.0, WAPI Supports 802.11w protected managed frames QoS support of WFA WMM, WMM PS Integrated LNA, PA, and T/R switch 2. Specification Model Name AI7697H Chipset MT7697N Core ARM Cortex-M4 MCU FPU Clock Speed 192MHz SRAM 352KB External Flash 4MB Dimension 18mm X 18mm X 1.
3. Pin Definition 20 19 18 17 16 15 14 13 SYS_RST_N GPIO38 GPIO37 3V3 GPIO36 GPIO35 GPIO34 GPIO33 GND NC. 3.1.
4. Operating Block 2.
PuTTY Program Command Product Name AI7697H MT7697 IoT SiP Module Version Date Page A FEB 21,2017 5 of 9
5. Software operating Connect the board to PC with a serial port cable. Build the example project and download the binary file to the MT7697. Reboot the HDK, the console will show "FreeRTOS Running" message to indicate the HDK is booting up. Use '?' and enter to query the available command line options. Note that the command line options are still under development and subject to change without notice.
If the IP address is fetched and the network is operating, the LinkIt 7697 can ping other devices/computer on the network with the following command in the console. f 11 10.10.10.254 3 64 Use the command 'ble ?' and enter to query the available Bluetooth command line options. Input the command "ble gap start_scan 0 0024 0011 1 0" in the serial tool to scan for the nearby Bluetooth enabled devices. 0, passive scan. 0024, scan interval (36 * 0.625 ms). Two bytes long HEX value.
6. Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
configurations or co-location with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID can not be used on the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC authorization.
