2.4GHz Wireless BlueTrace Mouse w/Type C Nano Receiver USER'S GUIDE Ver.:1.00 CAUTION: To use this product properly, please read the user's guide before installing.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Functional Introduction 1. Left button 2. Right button 3. Scrolling Wheel 4. Forward 5. Backward 6. DPI Switch Key (LED Indicator) 7. Nano Receiver 8. Battery Cover 9. Connect Button 10. ON/OFF Switch Forward Press this button to view the next page in your Internet browser. Backward Press this button to view the previous page in your Internet browser. DPI Switch The LED indicator under tilt wheel will light up when you plug the mouse into the USB port.
No light: 800 DPI The default setting is 800 DPI. You can easily switch between DPI settings. In order to save power, the LED display will only last for 10 seconds. Installing the batteries Step 1: Take the battery cover off. Step 2: Insert the battery as shown inside the battery compartment. Pull AA Battery X 1 Step 3: Replace the cover.
**Warning: *Please insert the battery with the correct position according to the instruction labeled on the mouse. Step 5: If you need to travel with your wireless mouse, made sure you turn off the POWER SWITCH. Setup the Connection between the Receiver and the Mouse 1. Insert the battery into the mouse, then follow the steps below. 2. In the meantime, to open the mouse under the cover, take the nano receiver out. 3. Plug the Nano receiver into the USB port on your computer. GREEN LED FLASH (0.5 sec.
press the connect button on the mouse. If the mouse does not work after 10 seconds, pair them again. (The receiver has auto pairing function). 6. The LED indicator on mouse flashes steadily when it is in pairing mode and stops blinking when it is successfully paired with the receiver. 7. When low battery, the battery indicator on the mouse will start to blink. DPI Switch Key LED Indicator *LED Indicator LED is on for 3 sec.