2.4GHz Wireless BlueTrace Mouse w/Nano Receiver USER'S GUIDE Ver.:1.00 CAUTION: To use this product properly, please read the user's guide before installing.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Functional Introduction 1. Left button 2. Right button 3. Scrolling Wheel 4. Forward 5. Backward 6. DPI Switch Key (LED Indicator) 7. Nano Receiver 8. Battery Cover 9. Connect Button 10. ON/OFF Switch DPI Switch The LED indicator under tilt wheel will light up when plug the mouse into USB port. The brightness of the indicator indicates the DPI setting in use. There are three different setting: Bright:1600 DPI Dim: 1300 DPI No light: 800 DPI The default setting is 1600 DPI.
Forward Press this button to view the next page in your Internet browser. Backward Press this button to view the previous page in your Internet browser. Installing the batteries Step 1: Take the battery cover off. Step 2: Insert the battery as shown inside the battery compartment. Step 3: Recover the cover. Pull AA Battery X 1 **Warning: *Please insert the battery with the correct polarity according to the instruction labeled on the mouse.
Step 4: Turn on power switch Step 5: If you need to travel with your wireless mouse, made sure turn off the POWER SWITCH. Setup the Connection between the Receiver and the Mouse 1. Insert the battery into the mouse, then follow the steps below. 2. In the meantime, a storage slot on the back to storage the receiver , take the nano receiver out.
3. Plug the Nano receiver into the USB port on your computer. GREEN LED FLASH (0.5 sec. Regularly) Se a rc hing the c ha nne l GREEN LED FLASH (if any action) Cha nnel c o nnec te d GREEN LED ON No a c tio n Connec t to the USB or Mouse port of your c omputer 4. If the mouse does not work, please put it into pairing mode. 5. Pairing: Re-plug the receiver into the USB port on your computer, then press the connect button on the mouse. If the mouse does not work after 10 seconds, pair them again.