User's Manual

You will need the following items:
• Attendance Rx™ software
(may already be installed, PN: 08-0137-000)
• ATRx ProxTime™
(
ATRx 10 Proximity Terminal, PN: 01-0206-000)
• 50 ft. RS232 ATR Communications Cable
provided by Acroprint
(PN: 72-0146-004)
• RJ11/DB 9-pin ATR Serial Adapter
provided by Acroprint
(PN: 63-0163-003)
• DC 12V Power Adapter
(PN: 56-0126-000)
• 15 Proximity Badges
(PN: 14-0123-002)
Attendance Rx must be installed prior to initial setup
and connection of ATRx10 proximity terminal. If
software is already installed proceed to step 2 of
Quick Start. If not, install Attendance Rx software by
inserting CD into CD-Rom. Follow and complete the
installation wizard.
To ensure PC meets the minimum system requirements,
see product box or refer to
www.acroprint.com.
ATRx ProxTime Quick Start
www.acroprint.com
1. Make sure PC is completely shut off.
To avoid damage to the PC port; PC power must be
completely shut off prior to attaching the ATR adapter
and ATR communications cable.
2. Connect ATR adaptor and ATR communications
cable (this may already be connected at the factory).
3. Connect the ATR adapter to the serial port on the
back of your PC.
4. Connect ATR communications cable to the white
port on the back of the ATRx10 proximity terminal.
** Do not connect to telephone wall outlet.
** Do not connect to modem port.
5. Plug DC 12V Power Adapter into the back of the
ATRx10 proximity terminal. ATRx10 will display PC
on the LCD screen until your PC is powered ON and
the Attendance Rx program is running.
Power on your PC and Attendance Rx should be
running. To confirm software is running, a System
Tray Icon will appear in the bottom right-hand corner
of your computer desktop screen
To enable ATRx
Terminal Manager, right
click the System Tray
icon, select Enable
Terminal Manager.
Software may automatically locate the PC serial
port. After the start-up sequence the Time and Day
of Week will display on the ATRx10 screen.
Note: If the connection fails the letters PC will dis-
play on ATRx10 screen. If this occurs, repeat steps
in Quick Start step 2 to ensure connections are
correct and proceed to Trouble Shooting portion on
the reverse side of the Quick Start.
Getting Started
Connect ATRx10
to IBM Compatible PC
Power Connection
Verify Terminal is
Communicating with PC
After following these steps, your set-up
should look like this diagram.
*Use enclosed wall template and four screws
to mount unit to wall stud.