User's Manual

ManualsBrandsAcroprint Time Recorder ManualsElectronicsENTRY CONTROL BADGE READER

NOTE

See Page 24 for USB to RS-232 Adaptor.

: Schematic connections are

hown from END VIEW (as viewed

from the outside of the connectors).

Schematic

“Standard” Modular Cable

(Adaptor A)

DB-9 to RJ-11 Adaptor

(Use DB-25 RS-232 Host Cable Assy. See pp. 24-25)

Cabling to Host Computer with DB-9 Port

Schematic

NOTE: Schematic connections are

shown from END VIEW (as viewed

from the outside of the connectors).

(Use DB-25 RS-232 Host Cable Assy. See pp. 24-25)

Cabling to Host Computer with DB-25 Port

Schematic

(Adaptor A)

DB-25 to RJ-11 Adaptor

Summary of content (5 pages)

PAGE 1
Cabling to Host Computer with DB-25 Port (Use DB-25 RS-232 Host Cable Assy. See pp. 24-25) DB-25 to RJ-11 Adaptor (Adaptor A) Schematic NOTE: Schematic connections are shown from END VIEW (as viewed from the outside of the connectors). Schematic Cabling to Host Computer with DB-9 Port (Use DB-25 RS-232 Host Cable Assy. See pp. 24-25) DB-9 to RJ-11 Adaptor (Adaptor A) “Standard” Modular Cable Schematic NOTE: Schematic connections are shown from END VIEW (as viewed from the outside of the connectors).
PAGE 2
Local Area Network: RS-485 Serial Port The RS-485 serial port is located on the lower left corner of the terminal. It is a six position 6-pin female port with the outer 2 pins to Ground. It will accept a male RJ-11 modular connector. The terminal can use RS-485 2-wire serial communication, allowing up to 32 terminals to be connected to one host port. An RS-232 port on the host is typically used in conjunction with an RS-232/RS-485 converter to complete the connection.
PAGE 3
RS-485 Serial Cables Junction Box “Daisy Chain” Wiring Diagram A RS485 Wiring Diagram The RS485 Serial port is located on the left corner of the terminal. RS485 is imprinted on the terminal casing. A RS485 communication allows up to 32 terminals to be connected to one serial port. An RS232 port on the host PC is used with an RS232/RS485 converter to complete the connection. B 16 B RS485 provides good protection from interference over long runs up to 4000 ft.
PAGE 4
Modem Port The port depicted may have either an RS-485, a Modem, or an Ethernet Communication Device. Terminals, which are equipped with a Modem port, will not have an Ethernet or RS-485 port. The Modem Port is a 6 position 4-pin female port, which will accept a male RJ-11 modular connector. The internal modem (modulator/demodulator) converts electronic data into tones, which are then transmitted over phone lines.
PAGE 5
Modem Cables Caution – To reduce the risk of fire, use only 26 AWG or larger telecommunication line cord. The cabling for modem operation is typically very simple. The modular connection uses the two inner wires of the RJ-11 jack for “tip” and “ring.” Connect one end of the cable to the terminal and plug the other end into your RJ-11 type modular telephone wall jack. The RJ-11 wall jack should be of the analog telephone type and not a digital network jack.