Quick start Guide

www.SleepPhones.com
WIRELESS CHARGING INSTRUCTIONS
Open the Velcro
®
in the back of the headband. Remove the Bluetooth
®
module by unplugging it from the speakers. Plug the micro-USB cable into
the micro-USB port on the Bluetooth
®
module. Plug the standard USB end
of the cable into the USB port on your computer or any USB wall adaptor.
The Bluetooth
®
module comes with a partial charge. When you plug the
module in to charge, you will notice a blinking red light. The red light will
turn off when the Bluetooth
®
module is fully charged. A fully charged
module will play for up to 13 hours.
Quick Start Guide
Before pairing, fully charge your SleepPhones
®
Wireless headphones.
Place your Bluetooth
®
device within 3 feet (1 meter) of your SleepPhones
®
.
Find the middle square button on the wireless Bluetooth
®
module located
inside the headband.
Press and hold the square button for 5 full seconds until you hear an
ascending 3 ring tone followed by a series of beeps. The series of beeps
indicate that the module is in pairing mode.
Next, go into the Bluetooth
®
settings on your device and turn on Bluetooth
®
.
After a few seconds, “AcousticSheep” will appear in the list of devices. Click on
“AcousticSheep” to pair your device to the Bluetooth
®
module. You will hear a
long beep to indicate that it is paired with your device.
-OR-
Navigate to the Bluetooth
®
connections menu on your Bluetooth
®
enabled device.
When “AcousticSheep” appears, click to pair your device to the Bluetooth
®
module.
You will hear a long beep to indicate that it is paired with your device.
PAIRING INSTRUCTIONS
To watch our video on how to use SleepPhones
®
Wireless
visit: www.SleepPhones.com/our-story/sleep-better-videos
The Bluetooth
®
word mark and logos are registered
trademarks owned by Bluetooth
®
SIG, Inc., and any use
of such marks by AcousticSheep LLC are under license.
Other trademarks and trade names are those of their
respective owners.
AS-SB-US-QUICK-03