ART 7 SERIES PROFESSIONAL ACTIVE SUBWOOFERS a new generation of speakers is born and it’s ready to rock audiences all over the world
english SAFETY PRECAUTIONS Before connecting and using the amplifier, please read this instruction manual carefully and keep it on hand for future reference. The manual is to be considered an integral part of the product and must accompany the amplifier when it changes ownership as a reference for correct installation and use as well as for the safety precautions. RCF S.p.A. will not assume any responsibility for the incorrect installation and/or use of the product.
english OPERATING PRECAUTIONS - Do not obstruct the ventilation grilles of the unit. Situate this product far from any heat sources and always ensure adequate air circulation around the ventilation grilles. - Do not overload this product for extended periods of time. - Never force the control elements (keys, knobs, etc.). - Do not use solvents, alcohol, benzene or other volatile substances for cleaning the external parts of this product.
english REAR PANEL FEATURES AND CONTROLS 2 3 4 1 STEREO JACK/FEMALE XLR INPUTS (BAL/UNBAL) The system accept jack or XLR input connectors. 2 LIMITER LED The amplifier has a built in limiter circuit to prevent clipping of the amplifiers or overdriving the transducers. When the soft clipping circuit is active the LED blinks orange. It is okay if the limit LED blinks occasionally. If the LED blinks frequently or lights continuously, turn down the signal level.
english CONNECTIONS The XLR connectors use the following AES standard: HOT PIN 1 = GROUND (SHIELD) PIN 2 = HOT (+) PIN 3 = COLD (-) COLD 2 1 3 GND BAL. XLR BEFORE CONNECTING THE SPEAKER On the back panel you will find all the controls, the signal and current inputs. At first verify that the voltage selector on the speaker is in proper position for your country (115 Volt or 230 Volt). The switch shall be in proper position (unless moved from unauthorized people), but a fast check will avoid problems.
italiano AVVERTENZE PER LA SICUREZZA IMPORTANTE. Prima di collegare ed utilizzare questo prodotto, leggere attentamente le istruzioni contenute in questo manuale, il quale è da conservare per riferimenti futuri. Il presente manuale costituisce parte integrante del prodotto e deve accompagnare quest’ultimo anche nei passaggi di proprietà, per permettere al nuovo proprietario di conoscere le modalità d’installazione e d’utilizzo e le avvertenze per la sicurezza.
italiano NOTE IMPORTANTI Per evitare fenomeni di rumorosità indotta sui cavi che trasportano segnali dai microfoni o di linea (per esempio 0 dB), usare solo cavi schermati ed evitare di posarli nelle vicinanze di apparecchiature che producono campi elettromagnetici di forte intensità (per esempio trasformatori di grande di potenza), cavi di rete, linee che alimentano altoparlanti. PRECAUZIONI D’USO - Non ostruire le griglie di ventilazione dell'unità.
italiano CARATTERISTICHE E CONTROLLI DEL PANNELLO POSTERIORE 2 3 4 1 INGRESSO JACK/XLR (SBILANCIATO/BILANCIATO) Il sistema accetta connettori di ingresso Jack o XLR. 2 LED DI INSERIMANTO DEL LIMITER L’amplificatore è dotato di un circuito di limiter in modo da prevenire il clipping dell’amplificatore o di sovraccaricare gli altoparlanti. Quando il circuito di soft clipping è attivo il LED lampeggia con colore ARANCIONE. È accettabile che il LED lampeggi occasionalmente.
italiano CONNESSIONI Il connettore di ingresso XLR segue il seguente standard AES: HOT PIN 1 = TERRA (GROUND ; SHIELD) PIN 2 = LATO CALDO (HOT ; +) PIN 3 = LATO FREDDO (COLD ; -) COLD 2 1 3 GND BAL. XLR PRIMA DI CONNETTERE IL DIFFUSORE Sul pannello posteriore trovano posto tutti i controlli, gli ingressi di segnale e di corrente.
ART 7 SERIES SUBWOOFERS TECHNICAL SPECIFICATIONS ACOUSTICAL Frequency response 45 - 120 Hz 40 - 120 Hz Max SPL 130 dB 131 dB Crossover Point 80 - 120 Hz 80 - 120 Hz 12” neo 3”voice coil 15” neo 3”voice coil 1000 Watt 1000 Watt TRANSDUCERS Low frequency AMPLIFIER Total power CONNECTIONS Signal Input/Output Combo Stereo Jack-XLR male / XLR female Power Input In-Out VDE AC socket Controls Phase, Crossover Switches ANALOG INPUT 2 way equalisation, Crossover Filtering Fast limiter RMS limit
RCF SpA Italy tel. +39 0522 274 411 fax +39 0522 232 428 www.rcfaudio.com www.rcf.it e-mail: info@rcf.it RCF UK Sales Office tel. +44 7005 402181 e-mail: info@rcfaudio.co.uk RCF Germany Sales Office tel. +49 2203 925370 e-mail: germany@rcf.it RCF USA Sales Office tel. +1 (603) 926-4604 e-mail: info@rcf-usa.com RCF France Sales Office tel. +33 6 07501800 e-mail: rcffrance@aol.