INSTRUCTION COPY AA001 - Bluetooth ® Class I Headphones – 90-day warranty - Soares Parts Diagram Transmitter Headphones 1_KNOB MUTE 2_MIC 3_KNOB VOL DOWN 4_KNOB POWER 5_KNOB PAIRING 6_INDICATOR OF POWER 7_ KNOB TELEPHONE 8_KNOB VOL UP 9_INDICATOR OF CHARGE 10_MINI USB JACK
Installation Transmitter 1. Plug the AC power adaptor in the DC jack, located on the rear of the transmitter. 2. Connect the included AC power adaptor to a wall outlet. 3. Connect transmitter and audio devices such as an ipod ® , TV, Monitor, VCR, CD/MP3/VCD/DVD players using a 3.5mm audio cable. 4. Press the POWER button for two seconds to turn on the transmitter. Headphones 1. Press POWER button for two seconds to turn on the headphone. P.
Initial Setup 1. Press POWER button on the headphones for two seconds and you will hear a wave sound when it is on. A blue LED quickly flashes and will be in pairing mode for the transmitter (or another Bluetooth ® devices). 2. Press Power button on the transmitter for two seconds. A blue LED quickly flashes, indicating that it is searching for the headphone. 3. Once transmitter and headphones are successfully linked, both blue LEDs flash slowly. 4.
. If the link is not successfully established, Press the PAIRING button on headphone and search the link with new BT devices 5. Your Bluetooth device (such as a PDA or cell phone) will display headphones as "AA001-RX" 6. Choose "AA001-RX" and enter the identification code “0000” 7. The blue power LED on the headphones flashes slowly, once the headphones are connected with your Bluetooth device. Handsfree Application with cell phone 1. Establish the connections between your cell phone and headphone. 2.
6. Answer the call by pressing TALK button on the headphones. The headphones will shift the link with you cell phone. 7. To end the call and return to the music, press the TALK button. WARNING: High volume level on your headphones may bring some adverse impact on your ears. Tune the volume to a comfortable level. SRS WOW SRS WOW is built-in in transmitter and is defaulted ON when playing music for TruBase and Surround Sound and Focus effects. is a trademark of SRS Labs, Inc.
Notes: ․ To protect the transmitter and to save power, the transmitter will shut off automatically if there is no/weak operation input signal from the audio source for four minutes. If the signal retunes, The transmitter will turn on again. Switch the headphones on by Pressing POWER button on headphones. The signal link between transmitter and headphone will be automatically re-established in few seconds.
․ Ensure the volume level of the headphone is adjusted properly. ․ The headphones are too far from transmitter, move closer. ․ The input level of the audio signal is too low. Turn up the volume of the audio source. Technical Specifications Transmission Mode Carrier Frequency Operation Voltage : : : Frequency Response Distortion S/N Ratio Operation Distance : : : : Blue Tooth Class I Version 2.0 stereo 2.4GHz Digital Transmitter, DC 6.0V 300mA Headphone, Rechargeable Lithium polymer 30Hz – 20KHz 0.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Bluetooth ® and the Bluetooth logos are trademarks owned by Bluetooth SIG, Inc, USA is a trademark of SRS Labs, Inc. WOW technology is incorporated under license from SRS Labs, Inc. P.
