User's Manual

ManualsBrandsACOM ManualsElectronicsHF+6m Linear Amplifier

2020

Fig. 5 - MENU SELECTION

5-1. Menu „Amplier measurements” – AMP MEASURE

The menu AMP MEASURE (Fig. 5-1) is accessible from the MENU SELECTION screen (Fig. 5) in all

modes. 11 parameter values be observed continuously.

Fig. 5-1 Menu “Amplier measurements” – AMP MEASURE

Two identical lists appear on the left and the right halves of the screen, each one containing the same

11 values.

Summary of content (4 pages)

PAGE 1
Fig. 5 - MENU SELECTION 5-1. Menu „Amplifier measurements” – AMP MEASURE The menu AMP MEASURE (Fig. 5-1) is accessible from the MENU SELECTION screen (Fig. 5) in all modes. 11 parameter values be observed continuously. Fig. 5-1 Menu “Amplifier measurements” – AMP MEASURE Two identical lists appear on the left and the right halves of the screen, each one containing the same 11 values.
PAGE 2
Any value can be selected in each screen half. Using buttons ITEM1 and ITEM2 (up and down) select the desired values. The two slected values will be shown continuously on the basic screen (S.3-2 (b), Fig. 3-2) - after leaving this menu (EXIT button). 5-2. Menu “Amplifier service functions” – AMP SERVICE. The amplifier service menu (Fig. 5-2) is accessible from the MENU SELECTION screen (Fig. 5) at RX mode only.
PAGE 3
If the amplifier CAT port is connected either to the transceiver BCD Band Data or Band Voltage output, select the respective interface type and push EXIT. The other items and values will not be taken into account. If the CAT cable is plugged into the transceiver’s serial port, select the interface and command set according to Table 5-1. The baud rate has to be set to the same value as the transceiver’s. The byte spacing and polling time may be left unchanged.
PAGE 4
5-4. “USER PREFERENCES” menu Fig. 5-4 – Menu USER PREFERENCES a) ANTENNA TUNER/SWITCH INSTALLED. If ACOM 04AT remote automatic antenna tuner is also installed, select YES. Refer to ACOM 04AT Operating Manual. b) AUTOMATIC MENU EXIT. When the option is turned on, the amplifier exits the currently selected menu if no button has been pressed for more than 5 minutes. If the option is turned off, the amplifier remains in the currently selected menu until the EXIT button is pushed. c) AUTO OPERATE.