User's Manual

ManualsBrandsACOM ManualsElectronicsHF+6m Linear Amplifier

2424

or involuntary switching to Operate mode. While locked, an attempt for entering Operate mode will result

in a message:

“OPERATE MODE IS LOCKED”

The other preference items need no explanation.

5-5. FAULTS LOG

This function reads on the screen the information stored in the memory about the last 28 HARD FAULT

protection trips (Fig.5-5). By pushing the FILE button, the information may be also downloaded in a plain-

text format le through the RS232 port and a computer using a standard terminal emulating program

(TTY). The RS232 protocol is: 9600, 8 N 1.

Fig. 5-5 Function FAULTS LOG

5-6. RESTORE DEFAULT SETTINGS

Four different factory reset levels are available (Fig.5-6).

In order to conrm the selected action the operator must push the ACTION - left (YES) button once

more. After restoring the default settings, the control will return to the MENU SELECTION screen - Fig.

5. If the ACTION – right (NO) button is pressed, the “NO” is selected again, and the control will not leave

the current position. At pressing the EXIT button in this position, the control leaves this menu without

changing anything and returns in the previous window (the MENU SELECTION screen – Fig. 5).

Summary of content (9 pages)

PAGE 1
or involuntary switching to Operate mode. While locked, an attempt for entering Operate mode will result in a message: “OPERATE MODE IS LOCKED” The other preference items need no explanation. 5-5. FAULTS LOG This function reads on the screen the information stored in the memory about the last 28 HARD FAULT protection trips (Fig.5-5).
PAGE 2
Fig. 5-6 Menu: RESTORE DEFAULT SETTINGS 6. REMOTE CONTROL 6-1. General information The ACOM 700S may be controlled remotely by the RS232 port. The ACOM 700S RS232 interface protocol is available on www.acom-bg.com. 7.
PAGE 3
Periodically check the SWR of the antennas and if this changes over time. Problems could occur more often in poor weather conditions – rain, snow, strong wind etc. b) Periodically (more often in a dusty environment, but at least once per year) clean the air filters without opening the amplifier. WARNING The air filters may be too dusty - be careful how you clean them so that you DO NOT INHALE (BREATHE IN) neither spill the dust over! Wrap it, for instance, in a wet cloth before cleaning! Fig.
PAGE 4
CAUTION Do not use solvents for cleaning – they can be dangerous to you, as well as to the coating or the amplifier plastic parts. In case of need, clean up the amplifier outside surfaces without opening it. Use a soft piece of cotton cloth, slightly moistened with clean water. 7-2.
PAGE 5
necessary instructions, if you choose to decode the downloaded hexadecimal data by yourself. 7-4. FIRMWARE UPDATES CAUTION Before you change the firmware version, check the new version compatibility with the revisions of the hardware and of the boot loader in your amplifier - see S. 5-5. If you have any doubts about the versions, please consult your dealer before you undertake any action.
PAGE 6
f) RF power gain: 14dB +/-1dB (typically 27W for 700W output power); g) Mains power supply voltage: 93-265VAC. h) Mains power consumption at full output power: 1350VA or less wth a power factor of 0.
PAGE 7
9. DISCLAIMER of LIABILITY All ACOM 700S specifications and descriptions are based on the latest information available at the time of this document’s printing.
PAGE 8
NOTES 31
PAGE 9
NOTES 32