User's Manual

ACLARA RF SYSTEMS
Formally HEXAGRAM, Inc.
30400 Solon Road.
Solon, OH 44139
440-528-7200
Thursday, August 26
th
, 2010
Users Manual
FCC ID: LLB10000
The LLB10000 has no user adjustment or controls and are installed by factories trained
personnel at the manufacturing facility. Aclara RF Systems formally Hexagram
LLB10000 devices are shipped to the customer in the sealed LLB10000 enclosures. Thus,
NO operational access can be made in the field, without breaking the factory sealed
enclosure.
The FCC wants you to know….. This equipment has been tested and complies with Part
15 and Part 90 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference. This equipment generates, uses and can radiate
radio frequency energy, and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, try to correct the interference by one
or more of the following measures: • Reorient or relocate the equipment. • Increase the
separation distance between the affected equipment and receiver. • Consult Hexagram,
Inc. for help. Any changes or modifications to this equipment not expressly approved by
the Hexagram, Inc. could void the authorization to operate the equipment. FCC RF
Exposure Guidelines Hexagram’s low power RF devices and their antennas must be
fixed-mounted on indoor or outdoor permanent structure(s) providing a separation
distance of at least 20 cm from all persons during normal operation. This device is not
designed (and it has no external connection) to operate in conjunction with any other
antennas or transmitters. No other operating instructions for satisfying RF exposure
compliance are needed. This unit has no user or installer serviceable parts, and requires
no field adjustment or calibration. Units are sealed at the factory, and disruption of this
seal could void the authorization to operate the equipment.
Sincerely,
Siva Jambulingam
Principal Engineer
Aclara RF Systems
440-528-7476
[e-mail]