User's Manual

ACLARA RF SYSTEMS
Formally HEXAGRAM, Inc.
30400 Solon Road .
Solon, OH 44139
440-528-7200
Monday, October 12, 2009
Users Manual
FCC ID: LLB09002
The LLB09002 has no user adjustment or controls and are installed by factories trained personnel
at the manufacturing facility .Aclara RF Systems formally Hexagram LLB09010B devices are
shipped to the customer in the sealed LLB09002 enclosures. Thus, NO operational access can
be made in the field, without breaking the factory sealed enclosure.
The FCC wants you to know….. This equipment has been tested and complies with Part 15 and Part 90 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference.
This equipment generates, uses and can radiate radio frequency energy, and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, try to correct the interference by one or more of the
following measures: • Reorient or relocate the equipment. • Increase the separation distance between the
affected equipment and receiver. • Consult Hexagram, Inc. for help. Any changes or modifications to this
equipment not expressly approved by the Hexagram, Inc. could void the authorization to operate the
equipment. FCC RF Exposure Guidelines Hexagram’s low power RF devices and their antennas must be
fixed-mounted on indoor or outdoor permanent structure(s) providing a separation distance of at least 20
cm from all persons during normal operation. This device is not designed (and it has no external
connection) to operate in conjunction with any other antennas or transmitters. No other operating
instructions for satisfying RF exposure compliance are needed. This unit has no user or installer serviceable
parts, and requires no field adjustment or calibration. Units are sealed at the factory, and disruption of this
seal could void the authorization to operate the equipment.
Sincerely,
Mark Wilbur
Mark Wilbur
Principal Engineer
RF and Microwave Systems
440-528-7200 [e-mail]