Control elements Lines play Sequencer: Synchronisation switch (1) to Sync out. Mode switch (19) to Play. Select Tempo with control (10), with rotary switch (11) and switch (14) Pattern. Tracer (16) is for start and stop. Step switches (17) and (18) change the number of steps of the sequence. Step switch (17) selects clocks in consequence between one or two; Step switch (18) between 12 or 16 steps for each pattern.
Lines write In order to write the entire memory of a Line fully, the step switch (17) is to set to x2, and the step switch (18) is to set to 16. Then two pattern with 16 steps each can be programmed. With the Pattern rotary switch (11) and the Group switch (14) the Pattern to write is selected. If the Mode switch (19) is set to Write, the sequencer jumps on the first step of the Line. With the pitch rotary switch (12) and the Oktave tracer (20) the pitch is determined.
Outputs CV and Gate outputs: Over the sockets CV Out and Gate Out (3.5 mm of mono) compatible synthesizer can be played. CV Out is a 1V/Oktave control voltage for the pitch, and gate Out is a +12V impulse with note length information. Audio outputs: Output is the main output (3.5 mm of mono), for a mixer connection. Headphones is a headphone output (3.5 mm stereo). Note: The produced bass frequencies are a large load for following amplifiers and loudspeakers.