ACER Monitor_SA240Y LIFECYCLE EXTENSION GUIDE 1
Contents Table of Contents Important Safety Notice------------------------------------------------------------------------------------ - 3 1. Exploded Diagram --------------------------------------------------------------------------------------- 4 2. W iring connectivity diagram -------------------------------------------------------------------------- - 5 3. Mechanical Instructure--------------------------------------------------------------------------------- - 6 4.
Important Safety Notice ACER S190HQL 1 Product Announcement: This product is certificated to meet RoHS Directive and Lead-Free produced definition. Using approved critical components only is recommended when the situation to replace defective parts. Vender assumes no liability express or implied, arising out of any unauthorized modification of design or replacing nonRoHS parts. Service providers assume all liability.
1.
2.
3. Mechanical Instruction Tools Required List the type and size of the tools that would typically can be used to disassemble the product to a point where components and materials requiring selective treatment can be removed.
4. Assembly and Disassembly Procedures Disassembly Procedure Step. 1 Pull the base & stand assembly out Step.2 Unscrew two screws at the I/O area Step.
Step 4. Pull up the rear cover and pull out all connectors Step.5 Disassemble deco cover. Step.6 Unscrew screws on main shielding case and disassemble Frame L&R.
Step.7 Remove F/B and take out the LCM, then separate Key board from F/B and LVDS cable from LCM Step.8 Remove FFC from display board Step.9 Unscrew four hex nuts and six screws and remove main board PCBA from main shielding.
Step.10 Disassemble rear cover assembly Step11.
Step12. Remove one screw and separate all silicon rubbers Step.
Assembly Procedure Step1. Assembly 8pin FFC to key board Step2. Assembly key board to rear cover Step3. If with speaker model, assembly speaker in rear cover and lock screw to fix. Step4. Tape speaker cable with acetate cloth tape (in yellow circle).
Step5. Assemble deco cover to panel. Step6. Assemble main board into shielding and put MB on panel side Step7. Assemble frame L&R and lock crews to fix Step8.
Step9. Lock crews to fix MB and use tape to tape cables Step10. Insert 6pin cable to panel and MB, use acetate tape to fix. Step11. Insert speaker cable to main board, use AL tape to fix.
Step12. Insert 8pin FFC to MB . Step13. Assembly rear cover, and push around the surrounding to assembly well. Step14.
5. Troubleshooting 5.
5.
5.
5.
6.