steppe To configure the Domain Name Server, simply select the Enable DNS option. Enter the Host and Domain, settings. Enter the DNS Server search order and click TCP/IP Properties steppe Once all the TCP/IP: properties “have been set, ‘click’OK to return to the Network window then click ‘OK to close the Network window.
a a steppe Click when prompted "Do you want to restart your computer now?" Configuring ‘the ADS’ modem for RFC1483 is completed: a 317 000163
steppe To setup the IP Address, select the IP Address tab and then select the "Specify an IP address” option. Enter the IP. Address and Subset Mask, setting, s Note: It 1577, at least for the last -sixteen digit for 1483 and steppe To setup a new gateway, © enter the setting in the: new gateway section ito the installed gateways.
steppe To configure the Domain Name Server, simply select the Enable DNS option Enter the Host and Domain settings. Enter the DNS Server search order and click . Once all the TCP/IP properties return’ fo: the. Network window.
Sept Click when prompted “Do you want to restart your computer now? Configuring the ADS modem for RFC1577 is completed. ins Change Activating The ADS ‘Network Mo den For RFC1483 and RFC i, Once the drivers.are ins! setup: is complete, the. “ADS Network Modem is ready to run. Each:time" the computers med on, the modem automatically connects” tithe: central ‘office equip : Uninstalling The Apollo ‘ADS Network Modem To uninstall the software drivers: 5.
Specifications 1.Protocol Support : 0S Protocol ‘Windows 98, RFC1483, RFC2364, RFC1577| Windows 2000 Second Edition NT4.0, 13 ; Windows 95, 98 RFC1483, RFC2364 Connector Pin out TAU-R SLAVONIC cards have JR-11 connectors. The JR-11 port is used for the ADS line connection. The table below describes the connector pin out for jacks. As a reference, the center two pins of each connector are thé TIP and RING pair.
Special Note: If the It Ex driver for RFC1433 bridged Ethernet is currently installed, then this driver needs to be removed prior to the installation of the Win Poppa protocol driver, Refer to the Apollo 2 ADS Network modem installation manual for removing, the RFC1483 bridged Ethernet driver, Conversely, if the RFC1483 bridged Ethernet. is to be reinstalled j the system, the. Poppa driver must. be removed before.
+ Setting up Poppa dial-up session: steppe Double click My Computer on the desktop. Then double click on the Dial-up networking. i 3% Floppy fc) + Winding's. f Cash: Scheduled x, _ web Folders Tasks : steppe Double click Make Néw ‘Connection totes up ‘Poppa’ Hal-up. 44.
steppe Double click the new icon (Here is Poppa) Specify the user name and password. Click : steppe Tf will start to connect tg the Poppa server and check the user name and password If they are correct, it will start logging on to the network. steppe This completes the dial-up installation and network configuration.
* Manually Entry of VPI & VCI Settings: Note: the values of the VPI and VCI can be manually set up by double clicking the It Ex ADS PICNIC in the Network icon n the Control Panel.