User Manual

ManualsBrandsACECAR ManualsCar & Vehicle ElectronicsCar Head Up Display,ACECAR 3.5 Inches Upgraded Universal Dual Mode HUD OBD2 GPS Interface Speedometer Compass Vehicle Speed Engine RPM OverSpeed Warning Mileage Measurement Compatible for All Vehicles

Car HUD Head Up Display

Model: M11

(This product Design Patent and Display Images Copyright had been registered with customs record)

HUD short for Head Up Display. It displays driving data on the car windshield such as

speed,RPM,water temperature,voltage,single mileage etc;avoiding drivers unsafely because of

watching the instrument while driving.Drivers can read the driving information instantly, and always

keep the best state on the way with HUD.

Kindly attention

OBD mode working voltage: 11V~18VDC (12vdc/200ma), when voltage is higher than 24v, please

use a USB cable for GPS mode

This product is a dual system (OBD2+GPS):the screen flickers after power on, press button to

select OBD2 or GPS system, if without operation,it will automatically enter the last selected system

after 5 seconds

Product functions:

1.Light sensor:HUD can automatically adjust the brightness according to the environment

2.Decorative lights: short press in button to turn it off

3.RPM icon: Engine speed in OBD mode, and speed progress bar in GPS mode.

4.Multiple functions:Speed,water temperature,voltage,satellite numbers,driving distance

Summary of content (6 pages)

PAGE 1
Car HUD Head Up Display Model: M11 (This product Design Patent and Display Images Copyright had been registered with customs record) HUD short for Head Up Display. It displays driving data on the car windshield such as speed,RPM,water temperature,voltage,single mileage etc;avoiding drivers unsafely because of watching the instrument while driving.Drivers can read the driving information instantly, and always keep the best state on the way with HUD.
PAGE 2
5.OBD system: after power on, OBD light flickers, press button within 5 seconds to switch GPS system 6.Driving direction: when the car speed exceeds 5KM/H, will display the driving direction. W=West, N=North, S=South, E=East 7.GPS system: after power on, GPS light flickers, press button within 5 seconds to switch OBD system GPS icon flashing to search the satellite, after received the satellite signal, the GPS light will be off after 5 seconds 8. Icon for Water temperature and battery voltage 9.
PAGE 3
4. Power switch : long press to turn off, do it again, turn on. 5. Connection port 1,connects to the cable 6. Connection port 2,connects to the cable, users can choose one of them. System switch When HUD power on, the screen flickers. Press to choose GPS or OBD system. After 5 seconds without operation, it will automatically enter the last selected system.
PAGE 4
Menu Functions Adjust Range Explanation speed 50-150 RPM alarm 10-75 Over Speed alarm 30-250 It will alarm after the vehicle speed reaches the default value of 150 150 Water temperature alarm 50-150 It will alarm after the water temperature is higher than the default value of 120 120 Voltage alarm 0-15.0 It will alarm if the voltage is lower than the default value of 10.0 volts 10.0 Fatigue driving reminder 1.0-8.0 Remind after continuous driving exceeds the default value of 4.
PAGE 5
Shutdown voltage 0-15.0 If it cannot auto turn off,change the voltage to 13.2V 0 Shutdown time 5-300 20 Reset 0-1 The default shutdown time is 20s,if your car is gas-electric hybrid or start-stop system,please delay the shutdown time(e.g. 180s),then the HUD will be turned off The default is 0. After adjusting to 1, press the M button for 5 seconds to save and exit. 0 Please note: please manually turn off the HUD,when you don’t drive your car for more than a week. Troubleshooting in OBD mode : 1.
PAGE 6
Find menu 10, adjust the default to 13.6-13.8 V Troubleshooting in GPS mode: 1.The screen without any display, and no power Check if the OBD cable or car charger cable is tightly connected, pull it down and insert it several times, or or plug the USB cable into the cigarette lighter. 2. No speed GPS flashing is trying to receive the satellite signal. Please drive the car to the empty road. After received the signal, the GPS icon will be off after a few seconds , then HUD can display the speed normally. 3.