User's Manual Part 3

ManualsBrandsAccurate Technology ManualsElectronicsTransmitter

ProScale M150, M250 and all products with General Purpose LCD Digital Displays 16 of 16

The Digital Display may be mounted in a location which allows for easy viewing by

the operator. The location of all parts should also safeguard the cable from

possible damage. ProScale wiring should be kept away from electrical wiring and

motors. Plug the readhead into the display. See Section 4:

Digital Display

Operation.

Typical Model 150 Installations

Moving Part

Connector Link

Readhead

Guide Clip

Scale

Readhead

Moving part

Readhead stationary, Scale moves

Scale stationary, Readhead moves

Summary of content (5 pages)

PAGE 1
5. The Digital Display may be mounted in a location which allows for easy viewing by the operator. The location of all parts should also safeguard the cable from possible damage. ProScale wiring should be kept away from electrical wiring and motors. Plug the readhead into the display. See Section 4: Digital Display Operation.
PAGE 2
Calibration Once installed, ProScale can be calibrated easily and quickly. Following is an example for calibrating ProScale on an industrial wide belt sander. Other installations follow the same general procedure. 1. Check to be sure installation of all parts is complete, all fasteners are secure, and the readhead is plugged into the digital display. 2. Set-up the machine to operate as normal. Run a part through the sander. 3.
PAGE 3
SECTION 3 PROSCALE MODEL 250 ProScale Model 250 shown with Panel Mount General Purpose LCD Display ProScale Model 250 A General Purpose measuring system with nine standard measuring ranges from 0-300mm (12in.) up to 0-6m (20ft.). Model 250 systems use ABS style scales, ABS style readheads, and any of the available digital displays. Neither the scale nor readhead are compatible with any Accurate Technology incremental technology measuring systems. ProScale Model 250 is easy to install.
PAGE 4
Installation 1. Note the orientation of the readhead on the scale. Be sure the arrow on the readhead points towards the “BLACK END OF SCALE”. This orientation is critical for proper operation of ProScale. Be sure the mounting location for the readhead and scale will allow this orientation. Take care when sliding the readhead onto the scale so the brass “fingers” inside the readhead do not get damaged. (A slight “wiggling” motion when installing the readhead on the scale will simplify the process.) 2.
PAGE 5
Typical Model 250 Installation M o vin g P a rt G u id e C lip R e a d he a d M o d e l 25 0 S ca le G u id e C lip R eadhead 2 1 .2 m m ( .8 3 " ) M o d e l 2 5 0 S c a le 3 3 .0 m m ( 1 .