— OFFICE = CONNECT. BETA DRAFT Part No OUA1675-1AAACT Published August 1998 Welcome © the works nth modern business a and sharing informatics are arc networks have proved [0 te one of communication.
P Alert LEC Power LED | orange green Off when the Hub is operating |™ indicates Collision LED novelize Flash each ume a Port Status LED green (100Mbps jink} / yellow (1086s link} if the LED 15 an, the link between the pert and » Newark Utilization Doled Y green J yellowish / orange correctly.
Before You Start Your Interoffice Dual Speed Hub 15 comes with Cra power adapter for use with the ub One power cord A Wa, return rant Registration car for you to fill out and Four rubber feet g clips An Office Connect Product Range sheet CD-ROM Thais guide four std! Workstation Connections To connect workstations or other equipment (such as servers) to your Hub, you need: Cne ABASE-T, or 2 100BASE-TX adapter card for each workstation.
Lee Ls PHL AOT] Positioning Your Office Connect Hub When installing your ®ub. ensure: = Isis out of direct sunlight and Away from sources of heat m Cabling 1s away ir fixtures. and seu transmitters ar a power es, fluorescent fighting Se such as radios, ’ Water or most's Air flow around the unit and sough the vents in the side of the case is not restricted. We recommend you provide 8 minimum of 25mm (Vin) clearance. Nat enter the excise of the unit. Wall Mounting the Office Connect Hub “CAUTION: Only.
Connecting Another Office Connect Hub You may wish to meantime another Office Connect hub 1 0 your Dubai Speed Hub 15. Alternate Wish 10 add your Hub to an network. When extending yo you may 25 green below, Fast Ethernet {100Mbps) Configuration Rules i The Dual Speed Hud 16 i5 2 Class Jl hub You can connect directly two Class i Fast Ethernet hubs (Class | Fast Ethernet hubs cannot ve connected directly 10 other Fast Ethernet: hubs). The total length of cable below) between two Workstations.
The Hub has teen desired to aid you when exacting and solving possible problems with your network. These problems are rarely senors. the cause is usually a disconnected or damaged incorrect configuration. If this action di your problem. contact your scragglier f on what to do next. rot see information Perform these acorns Ensure all network equipment 5 pov an Power gate piece of network equipment a7. wart about 5 seconds ang then power each one on Check tne flowing symptoms and solutions: Power LED not lit.
I FCC STATEMENT: This Equipment has hen tested ang found to comply with the limits for a class B digital device. Pursuant to Part 15 of the FCC rules. These Limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not instated and used in accordance with the instructions, may cause handful interference to radio communications.