Product Specification for EN1207B-TX 3 Version: 1.
The Federal Communications Commission Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
Tectonic Table of Contents Change History... 1. Product Description . 2. Features, 3 Hardware Specification 3.1 PC System. 3.2 Configuration... 3.3 Network Conformity 3.4 Power Characteristics 3.5 Environment. 3.7 LED indicator 3.8 Block Diagram 4. Software Specification... 4.1 Network Device Drivers Support 4.2 Network Operating Systems Support. 5. Predict Content... 5.1 Packaging Specification . 6. Certification Requirements... . 6.1 Network Operation System Certification. 6.2 Hardware Certification.
/Tectonic 1. Product Description 0. Introduction ENI207-TX 3 is 32-bit PIC-BUS Fast Ethernet Adapter, media support 100BASE-TX & 10 BASE-T. It is 4 Fast Ethernet Adapter with High Performance, High Reliability, Low Chip.Count, and Low Power Consumption. .
Acct on 2. Features Specifications: Standard Conformance Host Interface Ethernet Data Rate Media Connection 1/0 address Interrupt LED Driver support Temperature Humidity EMI Regulation IEEEB02.3u 100BASE-TX & IEEES02.3 BASE-T : PCI Bus compliant to PCI spec. 2.1 10 and 100 Bps ( Auto-negotiation) Single ROJAS for 100 BASE-TX & 10 BASE-T Auto selection Automatically decided by PCI BIOS Three LED for Link, 100M, Activity : Wetware ODIOUS Driver Nov ell Net Ware 4.1 4.11 DIS 2.
Omicron 2.2 Features + 10/100 Bps dual speed Auto negotiation . Meets PCI Local BUS Specification Rev. 2.1. . Automatic I/O Address and IRQ setup . Single JR-45 connector for 10/166 Bps operation . Provides full-duplex Ethernet operation for both ABASE-T and 100BASE-TX . 32 Bit data transfer with bus master for PCI interface * Three diagnostic LED for LINK, 100M, Activity + Low parer consumption and sleep mode . Conforms to IEEE802.3u 100 BASE-TX and IEEES02.
Acct on 3. Hardware Specification 3.1 PC System or Nola] a Bus PCI Bus Spec. Rev [2.1] Vv b Data Transfer 4 Bus Master 7 ¢. CPU M386 F386 Mesa 2 7 586 d. System Bus Clock [ 251033 MHz v e. PCI Signal Define : PRESENT# BAND LI PULL-U PRESENT BAND [PULL-UH Mo Sen MIGND_CIPULL-U 3.2 Configuration or No(x] RAM Size i 1KB b.RAM Address [ to 1H ¢.Lanl/O address ‘Auto Configure By BIOS [ [Selections v d Interrupt ‘Auto Configure By BIOS v e.
/Acton 4, Software Specification 4,1 Network Device Drivers Support The software supports are listed in the following table. Driver Program ENI207B-TX 4 Net Ware DOS ODI + 082 0D! ODI Server * SHIFT MSL Net Ware Universal Clientele) DIS INDIES (DOS, 082} NDIS(WFW311) 3.51, 4.0, 5.
4.2 Network Operating Systems Support (For reference only} Network Operating System/Protocol Driver Support DOSS ODI, 32-bit ODI. MSL IBM TCP/IP for DOS and 082 Net Ware 4.1 & 4.11 Microsoft Windows 95/98/NT DIS IBM LAN Server 2.43.3, 4.
Tectonic 5. Product Content 1 Product Content or No|x] PCB v T-Connector Manual Diskette * 1 (1.44MB) Power Adapter Module Media Module or Cable (for PCMCIA) Warranty Card Slim Red Box 5.1 The detailed packaging sp Packaging Specification cation is shown as below: 2 PCB Yes[¥] or No[x] a. Layers 4-layers, UJ 6-layers, [J 2 layers _ Vv b. Dimensions x [mm] 4.839 (Lx 4 finch] ¢. Connector fo media [TREE-45, LEBLANC, d Connector 0 host Optician Bus, [PCMCIA 0 . e. Connector 10 power Or.
Akron 5 Diskette a Type Mss + [Mamba] x [1)Qty v &. Drivers & Utility Ll Step [J Install bat © Release.doc 7 Directory for O AceView/Starion 0 Boot ROM v 7 Wetware DIS DOSS M1 Packet Driver HINT © Windows 95/98 Z Unix [J ponds 6 Power Adapter Module No [X] a Dimensions {Lyx {(W)x {D) b. Separate Power Cable Oa€, Ooc, Sec. e. Certification Ot, Orc, U 7 Media Module a Type T/p, TI v 8 Warranty Card Yes 9 Labels a. Certification b.
Acct on 6 Certification Requirements 6.1 Network Operation System Certification The list shows the requirements of certification for network operation system compatibility. Network Software Stems Yes|v'| or Noxious a. Nov ell Hardware Drivers ont v & Microsoft Hardware Driver Vv e. DEC PATCHWORKS Hardware Driver d.
6.2 Hardware Certification ‘The list shows the requirements for hardware certification /crouton Items ] | Yes[¥] or Nox] A. EMC 1 EMI: a FCC Patti M Class B , Ll Class A 2. EMS: a. Radiation Susceptibility F_ Conduction Susceptibility c. Lightning Surge Data Line (IEC 801.5) 1 2KV Power Line (IEEE 387): 1.5KV d Transient (IEC 801.4): IKV e ESD (IEC 801.