HIGH DEFINITION DIGITAL RECEIVER FULL HD 1080p TV STAR T1020 HD USB PVR USER MANUAL GB
Important Safety Instructions 1) Read these instructions. 2) Keep these instructions. 3) Heed all warnings. 4) Follow all instructions. 5) Do not use this apparatus near water. 6) Clean only with dry cloth. 7) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 8) Operate this product only from the type of power source indicated on the label.
1. RF IN: Use to connect an antenna. 2. RF LOOP THROUGH: Use it when connecting to another STB 3. COAXIAL: This socket connects to a coaxial socket on your home theatre 4. HDMI: High definition multimedia interface 5. TV SCART: Use this connector to connect your receiver with your TV set using a SCART cable 6. Analog audio R+L: analog audio output, left and right channels Remote Controle POWER: Switch the receiver in and out of standby model�. MUTE: Disable Audio output <0>-<9>: Numeric keys�.
To use the Remote Control, point it towards the front of the Digital Set Top Box. The Remote Control has a range of up to 7 metres from the Set Top Box at an angle of up to 60 degrees. The Remote Control will not operate if its pa h is blocked. Sunlight or very bright light will decrease the sensitivity of the Remote Control. Connecting to a Television For a basic connection from your Set Top Box to the television, use the Composite connection outlined below.
Program Manage Settings To access the Menu,press the M NU button and select [Program].Use the RIGHT/L FT keys to navigate through the menu.The Menu provide options to adjust the Program Mangage Settings.Select an option and press OK or RIGHT to adjust that setting.Press the XIT button to exit the Menu. (a) Program dit To edit your program prederences (lock/skip/favourite/move or delete),you will need to enter the Program dit Menu.This Menu requires a password to access. nter the default password’0000’.
(d) LCN (Logical channel number) Set LCN on or OFF if you want to sort the channels manually. Picture Setting To access the Menu,Press M NU then select [Picture] using the RIGHT/L FT key .The Menu provides options to adjust the video settings.Press UP/DOWN to select an option and press RIGHT/L FT to adjust that setting.Press XIT to exit the menu. (a) Resolution You can change this setting if the picture resoltion dose not apper to be correct.This setting is to match the most common setting for HDMI.
(b) Restore Factory Default Reset you STB to the Default Factory Settings. In Main Menu select [Restore Factory Default] using the RIGHT/L FT keys and press OK or RIGHT to select. nter your password or the default password ‘0000’ and press OK to confirm. This option will delete all preset channels and settings.
Note: We cannot guarantee compatibility (operation and/or bus power) with all USB mass storage devices and assume no responsibility for any loss of data that may occur when connected to this unit. With large amounts of data, it may take longer for the system to read the contents of a USB device. Some USB devices may not be properly recognized. ven when they are in a supported format, some files may not play or display depending on the content.