Instructions / Assembly

Recommended tools: Tape measure, drill with 1/4” masonry bit, four tap cons, four

washers, and a marker.

Before beginning: 1. Measure and write the a/c unit’s height, width and depth.

2. Remove all shrubs or debris from around ac unit.

3. When removing parts, keep level as parts can slide off

4. Place all box contents ﬂat on the ground, arranging sections in

Left, Front Center, and Right format, with stubs facing up.

Depth

Height

Width

1. Set Left, Front Center and Right sections ﬂat on the

ground,stubs facing up. See diagram 2

2. Align L-shaped bar with foot to the left and set screw facing up to

slide fully onto Left Section’s bottom bar See diagram 2.A

3. Align L-shaped bar with foot to the right and set screw facing up

to slide fully onto Right Section’s bottom bar See diagram 2.B

4. Insert ALL set screws loosely as these will need to be tightened

once cage’s ﬁnal dimension has been reached

5. Add 4 inches to the height dimension of your a/c unit

NOTE: Adjusting Front Center section fully will simplify assembly

Step-by-step instructions:

PAGE 1
Recommended tools: Tape measure, drill with 1/4” masonry bit, four tap cons, four washers, and a marker. Before beginning: 1. Measure and write the a/c unit’s height, width and depth. 2. Remove all shrubs or debris from around ac unit. 3. When removing parts, keep level as parts can slide off 4. Place all box contents flat on the ground, arranging sections in Left, Front Center, and Right format, with stubs facing up. 1. Width Depth 2C 2D Height 2B 3. 4. 2E 2A 5. 6.
PAGE 2
6. Measure Front Center section top to bottom and extend the cage to height required (#6) See diagram 2.C 7. Adjust this section’s square to be equal distance between top and bottom bar, while ensuring the height remains at the required dimension See diagram 2.D 8. Tighten 4 set screws on the cages’ Left and Right side bars 9. Add 6 inches to the width dimension of your a/c unit 10.Extend the cage left and right to width required (#11) See diagram 2.E 11.Tighten all remaining set screws on this section 12.