abode Outdoor Smart Camera User Guide May 13, 2020
Contents 1. Introduction 2. Application Overview 2.1. Parts Overview 2.2. Power Supply 2.3. LED Indicators 2.4. Equipment Required 2.5. Hardware Installation 2.6.
1. Introduction Outdoor Smart Camera (OSC) is designed to replace conventional doorbells by providing remote video streaming access, two-way communication via Wi-Fi network. OSC is an ACpowered video doorbell that is designed for you to view and speak with the visitor at the door with a smartphone from anywhere. OSC may also be used with the included DC-powered mount that allows the device to be used an an outdoor or indoor security camera.
5 6 Side (DC-Powered Attachment) 5 Side (AC-Powered Attachment) 1. Microphone 2. Lens 3. LED light ring 4. PIR sensor 5. Camera body 6. DC camera mount 7. Magnetic mount 8.
2.2 Power Supply The OSC uses 8~24V AC power or 5V DC power as its power source. For AC-Powered (Doorbell) Setup: Loosen the two screws on the back of the Doorbell Mount. Connect hardwired AC doorbell wires to the inputs on the mount and rescue screws. Install OSC Camera Body to the Doorbell mount by rotating the device 90 degrees to lock into place. Secure bottom security lock screw. *Note: It is recommended to use wire with a diameter less than 15mm to connect to the power input.
*Note: It takes about 1 minute for VDP to connect to Wi-Fi after power on. Before the Wi-Fi connection is established, the Red LED may flash momentarily. 2.4 Equipment Required The following equipment is required to use OSC: • A router supporting 2.4 GHz Wi-Fi network. The OSC should be connected to this router with access to internet and the Abode mobile app. • An iPhone or Android smartphone Android version requirement: Android 5.1 or above. iPhone version requirement: iOS 9 or above.
Mounting holes 8-24V wiring pins For DC-Powered (Security Camera) Setup: With the Corded Attachment unplugged from power source, rotate the Camera Body 90 degrees to lock into place on Attachment. Secure bottom security lock screws. Plug USB power cable into a 5V powered USB Type-A port to power camera, or plug USB power cable into included AC wall adapter. Plug wall adapter into wall to power camera. Step 3. If using Corded Attachment determine best placement of camera before permanently installing.
2.6 Setup with App The Video Door Phone can be either incorporated into existing Climax security system as an accessory device, or used as a standalone device. Determine which application should be used with your Video Door Phone before proceeding to setup process. OSC as an Alarm System Accessory In order to incorporate the OSC into existing Abode security system, the Control Panel of the security system must be registered with a user account in the Abode mobile app.
Abode App in App Store Outdoor Smart Camera Dashboard Preview OSC as a Stand-Alone Device Using OSC as standalone device does not require any other Abode security system panels. A smartphone with the Abode app installed is required to perform setup. Search for the app in Google Play or Apple App Store, type “abode” int the search bar, then download the application. 1. Open the Abode app and follow the prompts to create a new Abode account. 2. Power up OSC used the Corded Attachment.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.